ULINE H-2534 Towel Dispenser Installation Guide

June 7, 2024
ULINE

ULINE H-2534 Towel Dispenser Installation Guide

TOOLS NEEDED

  • Drill
    Drill

  • Drill Bit

  • Phillips Screwdriver
    Phillips Screwdriver

  • Level
    Level

  • Tape Measure

PARTS

  • Dispenser x 1
    Dispenser

  • Key x 2
    Key

  • **Screw x 4

**

  • Wall Anchor x 4

MOUNTING DISPENSER

NOTE: Recommended mounting height is 48″ from the floor to the bottom of the dispenser.

  1. Remove both keys from mounting plate. (See Figure 1)
    Remove both keys

  2. Remove mounting plate from dispenser by insertingkey into keyhole on top of dispenser and sliding the mounting plate down.

  3. Align mounting plate with labeled side facing the wall to desired position on wall.

  4. Mark holes and drill into wall surface.

  5. Insert anchors and top center screw.

  6. Place mounting plate on center fastener. Tighten screw while ensuring holes line up with all other anchors.

  7. Insert additional screws with mounting plate in level position and tighten all screws.

  8. Slide dispenser into place on mounting plate until it locks down. Dispenser is ready to load.

LOADING TOWEL ROLL

  1. Remove perforated cardboard core from center of the roll. (See Figure 2)
    LOADING TOWEL ROLL

  2. Pull toweling from the center of the roll and twist the end of the toweling enough to slide into dispensing cone. (See Figure 3)
    LOADING TOWEL ROLL

  3. Feed toweling through the dispensing opening at the bottom of the dispenser. Close dispenser. (See Figure 4)
    LOADING TOWEL ROLL

REMOVING DISPENSER FROM WALL

  1. Insert key into keyhole on top of dispenser.
  2. Press down and hold pressure on key while lifting up dispenser to disengage from mounting plate.

NOTE: Keep dispenser pressed tightly against wall while lifting.

Contact: 1-800-295-5510
Website; uline.com

uline

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals