Orimade B07Q3PVZFR Shower Caddy Instruction Manual
- June 17, 2024
- Orimade
Table of Contents
Orimade B07Q3PVZFR Shower Caddy
Product Information
Specifications:
- Product Name: Shower Caddy
- Origin: Made in China
- Usage: Bathroom
- Installation: Adhesive strips
Product Usage Instructions
Caution:
Please read this part carefully before installation. Clean and dry the surface before installation. Ensure adhesive strips are attached to a smooth surface. Squeeze out air when applying the adhesive strips. Wait 24 hours before using the product. Note that the adhesive strip is for single use. Use a hair dryer if you need to remove the adhesive strip.
Installation Steps:
Caution: The adhesive can be installed ONCE ONLY! Follow the instructions carefully.
- Clean the product installation surface, ensuring it is clean and dry.
- Prepare the adhesive and tear off the protective seal on the back. Stick the adhesive horizontally in the cleaned area, pushingout air bubbles from the middle to the sides, especially at the hook position. Ensure the adhesive is firmly pasted.
- Take out the rack and press it into the hooks as shown in the figure. Wait 24 hours before using.
Removal Tips: Use a hair dryer to heat the adhesive surface for easy removal. Wipe down any traces of adhesive strips left on the wall with alcohol after pulling off the strips.
FAQ
Q: Can I reuse the adhesive strips?
A: No, the adhesive strips are for single use only.
Q: What should I do if the adhesive doesn’t stick well?
A: Ensure you clean and dry the surface thoroughly before applying the adhesive. Press out any air bubbles during installation and wait 24 hours before using the product.
Caution
Please read this part carefully before your installation.
- Please clean and dry the surface before the installation.
- Please ensure the adhesive strips are attached on smooth surface.
- Please squeeze out the air when applying the adhesive strips.
- Please wait 24 hours before using the product.
- Please note that the adhesive strip is for single use.
- If there is any need to remove the adhesive strip, a hair dryer will give you a hand
This product is not suitable for the following wall surfaces
Installation Steps
Caution
The adhesive can be installed ONCE ONLY! Please follow the instruction carefully!
- Clean the product installation surface, ensuring surface is clean and dry
- Prepare the adhesive and tear off the protective seal on the back. Stick the adhesive horizontally in the area that being cleaned. We’ re gonna push all the air bubbles out,and we’ d better push them out from the middle to the sides, especially the hook position, in order to eliminate air. Make sure the adhesive is firmly pasted. This step is VERY IMPORTANT!
- Take out the rack. Press the rack into hooks, as shown in the figure.Waiting 24 hours before using.
Remove Tips: Use hair dryer to heat the adhesive surface. After heating, the film will be taken off easily.
The traces of adhesive strips left on the wall can be wiped down with alcohol after pulling offthe adhesive strips