vtech The Carson Playhouse User Guide

June 7, 2024
vtech

vtech The Carson Playhouse

product

INTRODUCTION
Thank you for purchasing the VTech® Toot-Toot Cory Carson® The Carson Playhouse! Get ready to play with Cory and Chrissy in their playhouse. Place the mini characters on the PlayZone location to hear fun phrases and sounds. Then, press the mailbox to launch the character.image
1

INCLUDED IN THIS PACKAGEimage 2

  • One label sheet
  • One Parent’s Guide

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy and should be discarded for your child’s safety.
NOTE: Please keep this Parent’s Guide as it contains important information.

GETTING STARTED

Battery Removal and Installation

  1. Make sure the unit is turned Off.
  2. Locate the battery cover on the bottom of the Base. Then, use a screwdriver to loosen the screw and remove the cover.
  3. Remove old batteries by pulling up on one end of each battery.
  4. Install 3 new AAA (AM-4/LR03) batteries following the diagram inside the battery box. (The use of new alkaline batteries is recommended for maximum performance).
  5. Replace the battery cover and tighten the screw to secure.

BATTERY NOTICE

  • Use new alkaline batteries or fully charged NI-MH (Nickel Metalhydride) rechargeable batteries for best performance.
  • Use only batteries of the same or equivalent type as recommended.
  • Do not mix different types of batteries: alkaline, standard (carbon-zinc), rechargeable or new and used batteries.
  • Do not use damaged batteries.
  • Insert batteries with the correct polarity (+ and -).
  • Do not short-circuit the battery terminals.
  • Remove exhausted batteries from the toy.
  • Remove batteries during long periods of non-use.
  • Do not dispose of batteries in fire.
  • Do not charge non-rechargeable batteries.
  • Remove rechargeable batteries from the toy before charging (if removable).
  • Rechargeable batteries are only to be charged under adult supervision.

WARNING:
Adult assembly required for battery installation. Keep batteries out of reach of children.

Disposal of batteries and product

The crossed-out wheelie bin symbols on products and batteries, or on their respective packaging, indicates they must not be disposed of in domestic waste as they contain substances that can be damaging to the environment and human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate that the battery contains more than the specified value of mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed on the market after 13th August, 2005. Help protect the environment by disposing of your product or batteries responsibly

VTech® cares for the planet.
Care for the environment and give your toy a second life by disposing of it at a small electricals collection point so all its materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.

LABEL APPLICATION

Please securely stick the labels to the play set as indicated below:image
3

ASSEMBLY INSTRUCTIONS

With The Carson Playhouse, safety comes first. Adult assembly is required. For your child’s safety, do not let them play with this toy until it is fully assembled.

  1. Place the Base on a flat surface and insert the House into the Base. Press down firmly, the house will click into place. Then insert the Halle Piece into the House.image 4

  2. Connect the Tyre Swing to the Tree and then insert the Tree into the Tree Base.image 5

  3. Connect the Seesaw to the Seesaw Base.
    The play set may be configured in a variety of ways:

  4. Connect the Tree and the House with the Ramp Track, as shown on the left. You can also connect the Tree to the House as shown on the right.image 7

Once you’ve completed the above steps, you are ready to play! Mini characters from other sets (each sold separately) are also compatible.image
8

PRODUCT FEATURES

  1. On/Off Switch
    To turn the unit On, slide the On/ Off Switch to the On position. To turn the unit Off, slide the On/Off Switch to the Off position.

  2. Automatic Shut-Off
    To preserve battery life, The Carson Playhouse will automatically power down after approximately 45 seconds without input. The unit can be turned on again by pressing the Mailbox Launcher or triggering the PlayZone Location with a mini character.
    NOTE: If the unit powers down while playing, please install a new set of batteries.

ACTIVITIES
  1. PlayZone Location
    Place Mini Cory, Mini Chrissy or other Toot-Toot Cory Carson® mini characters (sold separately) on the PlayZone Location to trigger fun phrases and sounds from the show. The characters will flash with the sounds.image
10

  2. Mailbox Launcher
    When a mini character is on the PlayZone Location, press the Mailbox Launcher to flip open the garage door and launch the mini character over the Ramp Track.
    WARNING: Do not aim at eyes or face. Do not launch any object other than the projectile provided with this toy.image 11

CARE & MAINTENANCE

  1. Keep the unit clean by wiping it with a slightly damp cloth.
  2. Keep the unit out of direct sunlight and away from any direct heat source.
  3. Remove the batteries if the unit will not be in use for an extended period of time.
  4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

  1. Please turn the unit Off.
  2. Interrupt the power supply by removing the batteries.
  3. Let the unit stand for a few minutes, then replace the batteries.
  4. Turn the unit On. The unit should now be ready to use again.
  5. If the unit still does not work, install a new set of batteries.
    If the problem persists, please contact our Consumer Services Department and a service representative will be happy to help you.

CONSUMER SERVICES
Creating and developing VTech® products is accompanied by a responsibility that we at VTech® take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to call our Consumer Services Department with any problems and/or suggestions that you might have. A service representative will be happy to help you.
UK Customers:
Phone: 0330 678 0149 (from UK) or +44 330 678 0149 (outside UK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: 1800 862 155
Website: support.vtech.com.au
NZ Customers:
Phone: 0800 400 785
Website: support.vtech.com.au

Product Warranty / Consumer Guarantees
UK Customers:
Read our complete warranty policy online at vtech.co.uk/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER GUARANTEES Under the Australian Consumer Law, a number of consumer guarantees apply to goods and services supplied by VTech Electronics (Australia) Pty Limited. Please refer to vtech.com.au/consumerguarantees for further information.

Visit our website for more information about our products, downloads, resources and more.
www.vtech.co.uk
www.vtech.com.au

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals