ULINE Mobile Dry Erase Board Installation Guide
- June 7, 2024
- ULINE
Table of Contents
MOBILE DRY ERASE BOARD
1-800-295-5510
uline.com
TOOLS NEEDED
TOOL INCLUDED
PARTS LIST
ASSEMBLY INSTRUCTIONS
-
Screw one braking and one non-braking caster into each foot. Fully tighten the nuts that accompany each caster. Insert one plastic end cap to the ends of each foot. (See Figure 1)
-
Insert one plastic end cap to the top end of each leg.
-
Attach one small U-bracket to each leg at the lower set of holes using 1¼” screws. Attach one large U-bracket to each leg at the upper set of holes, using 1¼” screws. (See Figure 2)
NOTE: Do not tighten screws until Step 9 is completed.
-
Attach one pivot stem to both sides of the panel using two 5/8″ screws for each pivot stem. Fully tighten screws. (See Figure 3)
-
Lay the leg and feet assemblies on a table. Position the legs so that the U-brackets face each other.
-
Place the panel between the legs, and insert the pivot stems through the top hole in each leg. Place a washer and knob on each stem. (See Figure 4)
NOTE : Do not fully tighten the knobs.
-
Attach one brace to each leg using one 1″ screw and one acorn nut. The brace slides over the small U-bracket. Repeat for the other leg. (See Figure 5)
-
Attach the marker tray to the leg assemblies by setting the marker tray on top of the large U-brackets and the braces. Align the holes and install one 1″ screw and one acorn nut through each of the four holes. (See Figure 6)
-
Place the unit upright and insert an end cap in the top of each leg. Tighten all screws and nuts to complete the assembly.
MOBILE DRY ERASE BOARD
1-800-295-5510
uline.com
Documents / Resources
|
ULINE Mobile Dry Erase
Board
[pdf] Installation Guide
Mobile Dry Erase Board
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>