ULINE H-2753 Conference Room Chair Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-2753 Conference Room Chair Installation Guide
PARTS
ASSEMBLY
- Insert casters into legs of five-star base. Turn base upright. Insert gas lift into center of base and place dust cover over gas lift. (See Figure 1)
- Align mechanism with holes on bottom of seat cushion with tension knob facing the front of seat. Use four 1/4 x 3/4″ screws (1) to secure. (See Figure 2)
NOTE : Use Allen wrench to tighten all screws. - Align armrest with holes on seat cushion and back cushion and use four 1/4 x 1″ screws (2) to secure loosely. Repeat on opposite side. Once all eight screws are installed, fully tighten. Insert plastic caps (3) in holes to cover screws. (See Figure 3)
- Slowly lower chair assembly onto the gas lift. Press down on seat cushion to secure. (See Figure 4)
CHAIR ADJUSTMENTS
-
Seat Height Adjustment – To raise seat height, lift lever up with little to no weight on the seat. To lower seat height, lift lever up while sitting.
-
Upright Tilt Lock – To lock chair in an upright position, push the lever in toward the center of the seat. To
restore tilt, pull lever out. Chair has standard tilt; the seat and back tilt simultaneously at the same ratio. -
Tilt Tension – To increase tilt tension, turn knob clockwise. To decrease tilt tension, turn knob counterclockwise.
1-800-295-5510
uline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>