ULINE Conveyor Gates User Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE Conveyor Gates User Guide
TOOL NEEDED
- 9/16″ (14 mm) Wrench
PARTS
-
Gate x 1
-
H-Stand x 4 (not included)
-
Steel Angle x 2
-
Gravity Roller x 2 (not included)
-
9/16″ (14 mm) Nut x 8
-
9/16″ (14 mm) Bolt x 8
-
Washer x 8
-
Split Washer x 8
INSTALLATION
NOTE: At least two people are needed to install gate.
-
While gate is at a 90° angle, line up bolt holes with H-stand holes. (See Figure 1)
-
Place gravity roller section on top of gate and line up with bolt holes in gate and H-stand. (See Figure 2)
-
Insert two bolts with split washers into lined-up bolt holes and hand tighten with washers and nuts to Repeat for opposite side. Once secured, use wrench to tighten. (See Figure 3)
-
On second gravity roller section, line up steel angle holes with H-stand. The steel angle should overhang the H-stand. Place gravity roller on top and line up bolt holes. Insert two bolts with split washers into lined-up bolt holes and hand tighten with washers and nuts to secure. Repeat for opposite side. Once secured, use wrench to tighten. (See Figures 4-5)
-
Lift gate lever to lower gate onto steel angle. (See Figure 6)
Contact Us
Phone: 1-800-295-5510
Web: uline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>