BraunAbility Carodoor Installation Guide
- June 7, 2024
- BraunAbility
Table of Contents
How to operate the Carodoor
When a wireless remote control fails Operate the Carodoor using the wheelchair lift’s original hand control.
In the event of complete power, loss Disconnect the wheelchair lift from the Carodoor unit.
- Remove the locking clip attached to the Carodoor link arm by pulling the red loop.
- Locate the red pry bar (should be attached to the lift pump housing). Place the pry bar between the door rod and motor arm and lever towards the motor housing to release the door rod.
- Open the doors manually.
If connected to the vehicle’s central locking system
- Unlock the vehicle.
- You have 4 minutes* to activate the lift before it looses power.
- If the time has run out and the lift is powerless, unlock the vehicle again or use the lift’s wired hand control to activate the system.
*** The 4-minute countdown is from version 3.2 of the circuit board.
Earlier versions have a 1-minute countdown.
Carodoor status LED-codes.**
The Carodoor control board is located inside the lift pump module.
Product certificate
Manufacturer / Braunability Europe AB Åkerivägen 7, 443 61 Stenkullen
Sweden.
Phone: +46 302 254 00
E-mail: info@braunability.eu
www.braunability.eu
Declares that the product / Carodoor
Conforms to following directives standards and regulations / 2006/42/EEC ECE R-10 BraunAbility Europe AB, Stenkullen 2019-04-02
Jan M Jensen
Managing Director
BraunAbility
Europe AB
Åkerivägen 7 443 61 Stenkullen Sweden.
Phone: +46 302 254 00
E-mail: info@braunability.eu
www.braunability.eu
References
- Vehicle adaptation solutions | BraunAbility Europe
- Vehicle adaptation solutions | BraunAbility Europe
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>