ULINE H-5121 Marine Shrink Cart Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-5121 Marine Shrink Cart Installation Guide
TOOLS NEEDED
3/8″ Combination Wrench or Socket Wrench
Hammer
PARTS
3/8″ Nuts x 8
Support Pole D-clip x 4
Caster/Frame x 2
Support Poles x 2
X-Support Poles x 2
ASSEMBLY
-
Attach X-Support Pole (E) to the bottom of Caster/ Frame (C) using 3/8″ nuts (A). Tighten nuts firmly, but not completely, in order to retain flexibility. Repeat process for the other Caster/Frame (C). Note: If the holes at the end of each X-Support Pole (E) do not line up, lightly tap the ends with a hammer until holes line up. (See Figure 1)
-
Attach X-Support Pole (E) to the backside of the Caster/ Frame (C) using 3/8″ nuts (A). Tighten nuts firmly, but not completely, in order to retain flexibility. Repeat process for the other Caster/Frame (C). (See Figure 2)
-
Place Support Poles (D) in U-shape holders on front side of Caster/Frame (C). Keep Support Poles in place by inserting Support Pole D-clips (B) in the holes on the U-shape holder. To insert Support Pole D-clips (B), first open the D-clip by pulling down on the spring, put through the two holes, and then release the spring. Repeat process for both Support Poles (D). (See Figure 3)
-
Double check all nuts and bolts used in assembly. Tighten each securely.
Contact Us
ULINE
Phone: 1-800-295-5510
Web: uline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>