ULINE MAGLINER Convertible Jr. Aluminum Hand Truck H-4937 Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE MAGLINER Convertible Jr. Aluminum Hand Truck H-4937
TOOLS NEEDED
PARTS
REF.
|
QTY.
|
DESCRIPTION
---|---|---
1
|
2
| Handle With Bracket
2
|
2
| 1/4 “ -20 x 1⁄ ” Pan Head Bolt
3
|
2
| 1/4 ” Locknut
4
|
1
| Extended Handle
5
|
1
| Frame
6
|
2
| Cotter Pin
7
|
4
| Thin Washer
8
|
2
| Wheel
9
|
2
| Thick Washer
10
|
1
| Left Hand (LH) Wheel Bracket
11
|
1
| Axle
12
|
2
| Roll Pin
13
|
1
| Right Hand (RH) Wheel Bracket
14
|
4
| 5/16 ” Locknut
15
|
2
| Side Channel Reinforcement
16
|
4
| 5/16 “ -18 x 2⁄ “ Hex Head Bolt
17
|
1
| Nose Plate
ASSEMBLY
ATTACH NOSE PLATE, WHEEL BRACKETS AND AXLE
-
Position side channel reinforcements against bottom frame rail. (See Figure 1a) Slide nose plate into channel on side channel reinforcement, keeping bolt holes aligned.
-
Insert four 5/16″-18 x 2 1/4″ hex head bolts through the nose plate, side channel reinforcements and frame.
-
Slide the right hand wheel bracket over the bolts on the outside of the frame leg and secure with two 5/16″ locknuts, but DO NOT tighten.
-
Lay hand truck on front so nose plate faces down.
-
Use a hammer to tap first roll pin into the axle.
-
Insert the axle (the end with the roll pin in place) through the upper axle hole in the wheel bracket. Rotate axle until roll pin locks into position in the wheel bracket.
-
Position and attach the left hand wheel bracket, sliding it over the axle to the outside of the frame leg. Secure with two 5/16″ locknuts, but DO NOT tighten.
-
Use a hammer to tap second roll pin into the axle.
ATTACH WHEELS
-
Slide one thick and one thin washer onto each end of the axle. Slide a wheel onto each end of the axle with long hub portion toward the wheel bracket. Slide a thin washer on each end of the axle.
-
Insert a cotter pin through the holes in each end of the axle. Bend cotter pins with pliers to secure wheels. Wheels should spin freely.
ATTACH HANDLES
-
To position handles, rotate away from the frame and line up the holes. Secure in place with two 1/4″-20 x 1⁄” pan head bolts and two 1/4″ locknuts.
-
Tighten all locknuts.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>