ULINE H-7053 Convergence Mesh Task Chair Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-7053 Convergence Mesh Task Chair Installation Guide
TOOL INCLUDED
PARTS
Back Support x 1
Seat Cushion x 1
Armrest x 2
5- star Base x 1
Screw x 3
Caster x 5
Washer x 3
Gas Lift x 1
ASSEMBLY INSTRUCTIONS
-
Insert casters into legs of five-star base. Turn base right side up. Insert gas lift into center of base. (See Figure 1)
-
Slide armrest into bracket on bottom of seat cushion until it clicks. Push in lever toward armrest to lock. Repeat on opposite (See Figure 2)
-
Position back support in slot between bottom of seat cushion and mechanism. Align holes and use three screws with washers to attach back support to (See Figures 3a – 3b) NOTE: Use Allen wrench to tighten all screws.
-
**** Slowly lower assembled chair and insert center of mechanism into gas Press down on seat to secure in place. (See Figure 4)
CHAIR ADJUSTMENTS
- Seat Height Adjustment – To raise seat height, lift lever up with little to no weight on the To lower seat height, lift lever up while sitting.
- Upright Tilt Lock – To lock chair in an upright position, push the lever in toward the center of the seat. To restore tilt, pull lever out. Chair has standard tilt; the seat and back tilt simultaneously at the same
- Tilt Tension – To increase tilt tension, turn knob To decrease tilt tension, turn knob counterclockwise.
- Lumbar Support – To position higher or lower on the back, slide the lumbar support up or
- Armrest Adjustment
(A) Height – To adjust arm height, press the button under armrest pad and move the armrest up or
(B) Width – To adjust arm width, pull lever under seat away from armrest and move the armrest in or Push lever in toward armrest to lock.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>