Mondaine SBB stop2go WiFi Clock User Guide
- June 3, 2024
- MONDAINE
Table of Contents
SBB stop2go WiFi Clock
User Guide
Mondaine SBB stop2go WiFi Clock
1. Remove the lid from the case back, place two lithium AA batteries in the
clock
2. Press both blue buttons to start the searching function
3. Take your mobile phone and go to yoursettings
4. Go to WLAN
5. Connect to the WiFi Clock
11. Press save your settings
12. Wait till the app successfully shows: Your Mondaine clock is connected
13. Please note that the time setting can take up to 2 minutes.
Reset: Set your WiFi Wall Clock to the factory settings
A- WiFi clock function description
- Stop2Go Function: the second hand turns 360° degree in 58.5 seconds, it stops at 12 o ‘clock and pause for 1.5 seconds
- EOL (end of life) Battery: If the hour and minute hands stops at 1:50, the battery voltage is low, and the battery needs to be replaced (lithium, alkaline)
- WiFi function: WiFi clock only supports 2.4G connection
B- Additional Setting Page Information
- The setting page has 4 languages to choose: English, German, Chinese, Japanese
- Search WiFi button: click WiFi (SSID) Dialog box will show the SSID with the strongest signal
- Reset button: click to set the interface content to restore the default value
- Save your Settings button: WiFi clock connected successfully: “Your Mondaine clock is connected “, then you can exit the mobile phone setting interface; WiFi clock networking failure: “Didn’t connect-try again “, Please check the WiFi Password and click again “Save Your Settings “
WiFi clock use, simple fault verification and solution
C- How to enter the Settings screen (Special case)
Due to compatibility limitation of some mobile devices, the following
situations may occur. The corresponding operations are as follows:
-
Case 1:
For example: After you select on your mobile device WLAN list – the clock, if the setting interface will not pop up automatically, but you have a notification in the notification bar indicating that the mobile device is connected to the WiFi clock. Click directly on the notification bar – the setting interface will pop up automatically -
Case 2:
For example: After you select on your mobile device WLAN list – the clock, if the setting interface will not pop up automatically also after you tried case 1, or it directly pop up a blank web page. Go to your mobile device internet browser and enter 192.168.4.1 in the URL field and click “search”, the setting interface will pop up
D- Fault verification and solution
-
Fault 1:
After the WiFi clock is powered on, the hands keep moving (it stops for a short time every 10 seconds and then starts again. Cycle). Solution: The battery is insufficient, replace the new battery (alkaline) -
Fault 2:
After setting the network, the hands stop at 12 o ‘clock when the WiFi clock cannot get the time, indicating that it didn’t connect correctly with your WiFi – restart the process at step 1 -
Solution:
Confirm whether the setting content (account and password) is incorrect, reset after click Save your Settings button and try again. Or re-power the WiFi clock connection Settings
Under the exclusive licence of the Swiss Federal Railways ( SBB, CFF, FFS)
according to the clocks in all SBB railway stations.
© All rights reserved and defended by the manufacturer and the Swiss Federal
Railways.www.mondaine.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>