DJO TRILLIANT Sniper Sterile Staple System Instructions
- June 7, 2024
- DJO
Table of Contents
SNIPER STERILE STAPLE SYSTEM
The Sniper Sterile Staple System is a premium, precise, and consolidated single kit composed of a dynamic compression staple, disposable deployment device, and instrumentation.
STAPLE SYSTEMS
- Fine trigger dispensing mechanism for accurate deployment without disruption to osteotomy/fracture site
- Low profile, high-strength, super elastic nitinol compression staple implants designed with dual-barbs intended to mitigate migration without increasing difficulty of revision
- A robust, stainless steel drill guide utilizes unique snap-off combo drill posts to allow for ease of use in staple placement
- Simple intra-operative staple reloading capabilities intended to minimize implant waste
- Available in 8x8x8mm and 10x10x10mm kit sizes
SNIPER STERILE STAPLE SYSTEM
| 
|
---|---|---
**Staple Size***|
8.0 x 8.0mm
|
10.0 x 10.0mm
Wire Size|
1.6 x 1.3mm
|
1.6 x 1.3mm
Part Number|
500-08-001
|
500-10-001
*Bridge Length x Leg Length
Sterile Kit Contents
SURGICAL TECHNIQUE
STEP 1: Place a bone clamp to create the necessary compression across the osteotomy of the fusion site (when applicable).
STEP 2: Place drill guide in desired position across the osteotomy or fusion site.
STEP 3: Drill the first hole in the bone using the snap-off drill post provided. Toggle the proximal shaft of the snapoff drill post to remove the drill shaft and create a post.
STEP 4: Pivot position of the drill guide if desired.
STEP 5: Drill second hole using additional snap-off drill post provided.
STEP 6: Remove drill guide and post. Insert staple legs into pre-drilled holes until the distal tip of the deployment device abuts the osteotomy site.
STEP 7: Press trigger to deploy the staple.
STEP 8: Fully seat the staple.
STEP 9 (OPTIONAL): The distal section of the deployment device may be utilized as an impactor to fully seat the staple if deemed necessary by the surgeon.
STAPLE RELOADING (IF NECESSARY)
STEP 1: Insert staple legs into the applicable holes in the safety cap.
STEP 2: Press firmly until staple is fully seated and legs are in the parallel orientation.
STEP 3: Press trigger to open deployment device and align staple bridge over distal groove of the dispenser.
STEP 4: Release the trigger and push barrel forward to reload the staple.
STEP 5: Remove staple from the safety cap.
FDA cleared 510(k) K162354.
Trilliant products are made in the U.S.A.
T 800.495.2919 F 877.778.3864
727 North Shepherd Drive, Suite 100 | Houston, TX 77007 | U.S.A.
djoglobal.com
Copyright © 2021 by DJO, LLC
900-00-083 Rev G
Individual results may vary. DJO, LLC is a manufacturer of orthopedic implants
and does not practice medicine. Only an orthopedic, or foot and ankle surgeon
can determine what treatment is appropriate.
The contents of this document do not constitute medical, legal, or any other
type of professional advice.
This material is intended for the sole use and benefit of the DJO, LLC sales
force and physicians.
It is not to be redistributed, duplicated, or disclosed without the express
written consent of DJO, LLC.
For more information on risks, warnings, and possible adverse side effects
refer to the Instructions for Use provided with the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>