ANKER PowerCore Slim 10000 PD Power Bank User Manual
- June 6, 2024
- Anker
Table of Contents
ANKER PowerCore Slim 10000 PD Power Bank User Manual
Charging Your Phone or Tablet
Charging Your Bluetooth Earphones or Smart Watches
- Enter “trickle-charging” mode: Press the power button twice or press and hold for 2 seconds. The LED indicator will turn green.
- Charge your devices recommended for smart watches or Bluetooth earphones
- Exit “trickle-charging” mode: Press the power button once again.
Recharging Your PowerCore
Recharge your PowerCore via a PD charger ( not included).
Specifications
Capacity
|
10,000mAh / 37Wh
---|---
USB-C Input
| 5V 3A, 9V 2A, 15V 1.2A
USB-C Output|
5V 3A, 9V 2.22A
USB-A Output
| 5V 2.4A
Total Output|
5V 3.6A
Size
| 149.5 × 68.5 × 14.5 mm
Weight|
212 g
Important Safety Instructions
When using this product, basic precautions should always be followed, including the following:
- Store product in a cool and dry place.
- Do not store the product in hot or humid environment.
- Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons.
- Operating temperature should be between 32°F to 95°F / 0℃ to 35℃
- Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
- If the product is not used for long periods of time, you should change and discharge once every three months.
- When charging a device, the product may feel warm, this is a normal operating condition and should not be cause forconcern.
- In normal conditions, the battery performance will decline over several years.
- Do not dispose of the product in heat or fire.
- Do not clean the product with harmful chemicals or detergents
- Misuse, dropping or excessive force may cause product damage.
- When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.
- Be aware discharged battery may cause fire or smoke, tape the terminals to insulate them.
This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
WARNING: The batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Extremely low air pressure that may result in an explosion or the leakage of
flammable liquid or gas.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party.
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 (800) 988 7973
This device complies with Industry Canada license‐ICES003. Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Customer Service
18-Month Limited Warranty
Lifetime Technical Support
Email: support@anker.com
Phone:
(US) +1 (800) 988 7973 Mon-Fri 9:00 – 17:00 (PT)
(UK) +44 (0) 1604 936200 Mon-Fri 6:00 – 11:00 (GMT)
(DE) +49 (0) 69 9579 7960 Mo-Fr 6:00 – 11:00
( 日本 ) (0)3 4455 7823 月 – 金 9:00 – 17:00
( 中国 ) +86 400 0550 036 周一至周五 9:00 – 17:30
+971 42463266 (Middle East & Africa) Sun-Thu 9:00 –
17:30 (GMT+4)
+971 8000320817 (UAE) Sun-Thu 9:00 – 17:30 (GMT+4)
+966 8008500030 (KSA) Sun-Thu 8:00 – 16:30 (GMT+3)
+965 22069086 (Kuwait) Sun-Thu 8:00 – 16:30 (GMT+3)
+20 8000000826 (Egypt) Sun-Thu 7:00 – 15:30 (GMT+2)
For FAQs and more information, please visit:
@Anker
@Anker Japan
@Anker Deutschland
@Anker Official
@Anker_JP
@anker_official
@anker_jp
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>