logitech 910-005270 Wireless Pro Gaming Mouse User Guide
- June 6, 2024
- Logitech
Table of Contents
PRO WIRELESS
SETUP GUIDE
|
---|---
Important Safety, Compliance, and Warranty Information
SETUP INSTRUCTIONS
-
A wireless receiver attached to the USB adapter can be found 1
in the accessory box Plug one end of the cable into your PC, and the other end into the USB adapter and receiver
The receiver can also be used plugged directly into your PC However, using the cable and adapter when in wireless mode is recommended and allows for better connectivity and easy access to the cable for recharging
-
Turn mouse on via the switch on the bottom of the mouse
www.logitechG.com/support/pro-
wireless -
Download Logitech Gaming Software
-
To charge, disconnect the cable from the adapter and plug it into the front of the mouse, Your mouse will operate in data‑over‑cable mode whenever it is plugged in directly to a PC Full charge from empty requires around 2 hours plugged into a PC USB port
Tips:
– Keep the mouse and receiver 2 m+ away from wireless routers or other 2 4GHz
wireless devices to minimize environmental noise
– PRO WIRELESS has a wireless range of up to 10 meters To ensure optimal
performance in noisy wireless environments, and to keep the charging cable
easily accessible,
it is recommended to keep the receiver within 20 cm of the mouse
BUTTON CONFIGURATIONS
PRO WIRELESS comes with replaceable buttons and button caps, which are held onto the mouse magnetically These should be stored in box when not in use These replaceable buttons support conversion to the following configurations:
| 
---|---
| 
FULLY PROGRAMMABLE BUTTONS
| 
---|---
1 Left (Button 1)| 6 Back (Button G6)
---|---
2 Right (Button 2)| 7 Forward (Button G7)
3 Wheel click (Button 3)| 8 DPI cycle (bottom of the mouse, Button 8)
4 Back (Button G4)| 9 Receiver storage door + Powerplay module enclosure
(bottom of the mouse)
5 Forward (Button G5)| 10 On/Off switch (bottom of the mouse, not
programmable)
BATTERY LIFE
PRO WIRELESS has a rechargeable 250mAH LiPol battery which
provides it with up to 60 hours of non‑stop gaming at 1ms report
rate with lights off, or 48 hours non‑stop gaming at 1ms report
rate with RGB color cycling on *
– Charge level can be checked when the mouse is powered on or using Logitech
Gaming Software to assign a button to check the charge level
– Charge level is displayed for seven seconds at mouse power‑on using the
color and number of bars illuminated on the DPI indicator:
– 3 green dots = 50–100%
– 2 green dots = 30–50%
– 1 green dots = 15–30%
– 1 flashing red dot = <15%
Tips:
– You can program a button to show charge level using LGS
– The bottom dot will flash red when the battery is at 15% or less When this
happens, plug in your mouse to charge
– Charge level, power draw, and estimated remaining battery life can be
checked in Logitech Gaming Software
*Battery life and capacity may vary with age and use Rechargeable batteries have a limited number of charge cycles
CHARGING/DATA OVER CABLE
Plug your mouse in via the provided USB charging cable when the battery is low PRO WIRELESS is also compatible with the Logitech G POWERPLAY wireless charging system, sold separately
LOGITECH GAMING SOFTWARE
You can customize the onboard profile settings using the Logitech Gaming
Software These settings include button programming, report rate,
performance/endurance modes and tracking behavior PRO WIRELESS allows up to 5
DPI settings By default, PRO WIRELESS has the following settings:
– DPI: 400/800/1600/3200
– Report rate: 1ms
– Performance mode
DPI/ONBOARD PROFILE INDICATORS
DPI/Onboard profiles are shown using three LEDs under the main buttons The image below shows which values are being indicated by the LED panel
FREQUENTLY ASKED QUESTIONS
http://support.Logitech.com/product/pro‑wireless
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>