Connects2 CAM-MB5.2 Mercedes Brake Light Reverse Camera User Manual
- June 6, 2024
- Connects2
Table of Contents
Connects2Vision
User Manual
CAM-MB5.2
Mercedes Brake Light Reverse Camera
Mercedes Benz Sprinter (W906) 2006 – 2016
PRODUCT FEATURES:
Image Sensor: 1/3” CMOS
Resolution: 510 x 492 (NTSC), 500 x 582 (PAL)
TV Lines: 700
Signal System: NTSC/PAL
Minimum Illumination: 0 Lux (LED’s on)
Infra-Red LED’s: Yes
Built-in lens: f-2.8mm
Waterproof Rating: IP69K
Viewing Angle: 120° (Diagonal) x 95° (Horizontal) x 75° (Vertical)
Electronic Shutter: 1/60 (NTSC) 1/50 (PAL) – 1/100,00 second
Operating Voltage: 12V DC (Negative Ground)
Current Consumption: 90-138mA @ 13.8V
Operating Temperature: -30 Degrees C to +70 Degrees C
Certification: FCC, CE, E-mark, ISO9001,TS16949, RoHs
DISCLAIMER:
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for
installation.
Please ensure you use the correct tools to avoid damage to the vehicle or
product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 wants to provide a fast and suitable resolution should you encounter
any technical issues. With this in mind, when contacting Connects2, try to
provide as much information as possible. This will speed up the process and
help us to help you.
Please use our dedicated online technical support center:
support.connects2.com
CONTENTS
- Brake light camera with 35cm cable to Male 4pin camera connector.
- 10m Male to Female 4pin extension cable
- Instructions
INSTALLATION
- Remove the factory-installed third brake light from the vehicle and unplug the connection cable.
- Connect the new combined brake light/camera assembly to the brake light connector and test to ensure correct brake light operation, taking care not to trap any cables.
- Connect the Black wire to a suitable ground and connect the Red wire to the reversing light circuit or an interface that provides a reverse signal.
- Connect the camera to the 4pin extension cable, connect the extension cable to the camera connection cable and connect the camera connection cable to the display screen via the Yellow RCA connector and ensure that the image is displayed correctly.
PAL / NTSC SELECTION
To select PAL – leave the green wires separated
To Select NTSC – Connect the Green wires together
Subscribe to our YouTube Channel for installation
guides and tips…
www.youtube.com/connects2
www.connects2.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>