Razor E200 Motor Wide Metal Belt Sprocket Instruction Manual

June 6, 2024
Razor

Razor - logo

E200, E300 MOTOR INSTALLATION INSTRUCTIONS
PART# W13112099030; W13113640030

Required Tools: ( Not included)

  • Phillips screwdriver
  • 8 mm wrench
  • 4 mm Allen wrench

  WARNING

  CAUTION: To avoid potential shock or another injury, turn the power switch OFF and disconnect the charger before performing any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

Step 1
Using a Phillips screwdriver, remove the four (4) screws on the deck plate.
Razor E200 Motor Wide Metal Belt Sprocket Instruction - step
1 Step 2
Using a Phillips screwdriver and a 8 mm wrench, remove the two (2) screws and locknuts on the rear deck plate.

Razor E200 Motor Wide Metal Belt Sprocket Instruction - step
2

Step 3
Using a 4 mm Allen wrench, remove the two (2) hex bolts. Remove the deck plate and set aside.
Razor E200 Motor Wide Metal Belt Sprocket Instruction - step
3 Step 4
Using a Phillips screwdriver, remove the two (2) screws on the battery bracket. Remove battery bracket and set aside. Carefully lift out the batteries from the battery tray.
Razor E200 Motor Wide Metal Belt Sprocket Instruction - step
4 Step 5
Using a Phillips screwdriver remove the screws on the chain guard. Remove the chain guard and set aside.
Razor E200 Motor Wide Metal Belt Sprocket Instruction - step
5 Step 6
Using a Phillips screwdriver remove the four (4) screws that hold the motor to the frame, turn the motor clockwise. This will allow you to remove the chain from the sprocket on the motor.
Razor E200 Motor Wide Metal Belt Sprocket Instruction - step
6 Step 7
Disconnect the motor from the controller and using a small screwdriver or even a paper clip depress the locking pin on the prongs. Remove the connector from the wires, if you are not reusing your motor you can just cut the wires.
Razor E200 Motor Wide Metal Belt Sprocket Instruction - step
7 Step 8
Turn the motor counterclockwise so that the shaft from the motor points to the front of the unit and slide the motor down and pull the wires from the battery tray.
Razor E200 Motor Wide Metal Belt Sprocket Instruction - step
8 Step 9

  • Reverse the procedures.
  • Mount your motor on the frame and insert the wires into the battery tray
  • Before securing the motor with the screws install the chain onto the sprocket on the motor and then fasten the screws
  • Install the white connector on the wires from the motor (black wire on motor connects to brown or yellow wire from controller and red from the motor connects to the blue wire from the controller) and reconnect controller and motor.
  • Place the batteries back on the battery tray and secure them with a battery bracket and reinstall the chain guard.
  • Re-attach deck cover with screws and hex bolts…
    Attention: Charge battery 12 hours before using

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00 AM – 5:00 PM PST.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals