THE OUTDOOR GREATROOM Round Glass Guard Instruction Manual
- June 6, 2024
- THE OUTDOOR GREATROOM
Table of Contents
THE OUTDOOR GREATEOOM COMPANY
Round Glass Guard Assembly Instructions
HOT GLASS WILL CAUSE BURNS DO NOT TOUCH GLASS UNTIL COOLED NEVER ALLOW
CHILDREN TO TOUCH GLASS
WARNING
- Children and adults should be alerted to the hazards of high surface temperatures and open flames and should stay away to avoid burns or clothing ignition.
- Young children should be carefully supervised when they are in the area of the appliance.
- High Temperatures may ignite clothing or other flammable materials.
- Clothing or other flammable materials must not be placed on or near the glass guard
INCLUDED IN THIS KIT
ATTENTION:
Before you begin assembly, inspect all parts for damages.
ASSEMBLY INSTRUCTIONS
Assemble glass guard upside down, and flip over after assembly.
Required Tools:
- Phillips head screwdriver – for tightening rod
- Flathead screwdriver – for tightening set screws
- Soft leather gloves – for handling glass panel
Insert glass panels into top clips (without through holes) as shown above.|
Secure bottom clips to glass panels as shown above.
---|---
Insert the rod through the pad, then the bottom clip and
finally screw into the top clip as shown above.
Using a Phillips head screwdriver, tighten rods into the top clip so the last thread is not visible. Flip glass guard over once fully assembled.
Using a flat head screwdriver, hand tighten set screws on both top and bottom clips. Tighten until the silicone pad makes contact with the glass surface and then turn 1.5 to 2 turns beyond.
WARNING
Allow glass to cool before touching. If picking up the glass guard to move for
any reason, grip the middle of
two opposite glass panels and apply constant pressure towards the inside of
the glass guard.
CARE AND USAGE TIPS
- Clean glass with water, white vinegar, or commercially available streak-free glass cleaner and a soft cloth.
- Never attempt to clean the glass while hot.
- DO NOT touch the glass while in operation or for 10 minutes following use. IT WILL BE HOT!
- For a permanent installation, outdoor-rated silicone adhesive can be used to affix Glass Guard to a fire pit surface.
- Check that rods and clips are secured every few months. Tighten rod with a screwdriver if loose.
The Outdoor GreatRoom Company Glass Guards Limited Warranty
The Outdoor GreatRoom Company extends the following warranty for Outdoor
GreatRoom Glass Guards used in the United States of America or Canada. Dealers
and employees of The Outdoor GreatRoom Company have no authority to make any
warranty or authorize any remedies in addition to or inconsistent with the
terms of this warranty. This warranty gives you specific legal rights. You may
also have other rights that vary from state to state.
The Outdoor GreatRoom Company warrants that this Outdoor GreatRoom Glass Guard
(the “Product”) will be free from defects in material and workmanship for a
period of 90 days from its date of purchase. Stainless steel parts and
assemblies carry a limited lifetime warranty. This warranty is subject to the
conditions, exclusions, and limitations described below.
This warranty applies only to the original owner of the Product and is non-
transferable. The Outdoor GreatRoom Company obligation under this warranty
does not extend to damages resulting from (1) assembly, operation, or
maintenance of the Product not in accordance with the Installation/Assembly
Instructions, Operating Instructions
and the Listing Agency Identification Label furnished with the Product; (2)
installation or use which does not
comply with local building codes and ordinances; (3) shipping, improper
handling, improper operation, abuse,
misuse, accident or unworkmanlike repairs; (4) use of fuels other than those
specified in the Operating
Instructions; (5) Installation or use of components not supplied with the
Product or any other components not
expressly authorized and approved in writing by The Outdoor GreatRoom Company;
and/or (6) modification of the Product not expressly authorized and approved
in writing by The Outdoor GreatRoom Company. Any of the circumstances
described in the previous sentence voids this warranty. This warranty is void
if the Product or any component has been removed, repaired, or replaced before
The Outdoor GreatRoom Company has been afforded a reasonable opportunity to
inspect the Product.
This warranty is limited to the replacement or repair of defective components
or workmanship and The Outdoor GreatRoom Company may fully discharge its
obligations under this warranty by repairing or replacing, at its discretion,
the defective components. The Outdoor GreatRoom Company will provide
replacement parts at no charge and will pay reasonable and necessary labor and
freight costs related to replacing or repairing defective components under
this warranty. The maximum amount recoverable under this warranty is limited
to the purchase price of the Product and, if The Outdoor GreatRoom Company is
unable to provide replacement or repair in an expedient and cost-effective
manner, The Outdoor GreatRoom Company may discharge all obligations under this
warranty by refunding the purchase price of the Product.
EXCEPT TO THE EXTENT PROVIDED BY LAW, THE OUTDOOR GREATROOM COMPANY MAKES NO
EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSED THEREIN. THE DURATION OF
ANY IMPLIED WARRANTY IS LIMITED TO THE DURATION OF THE WARRANTY SPECIFIED
ABOVE. IN NO EVENT SHALL THE OUTDOOR GREATROOM COMPANY BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES CAUSED BY DEFECTS IN THE PRODUCT. Some
states do not allow limitations on how long an implied warranty
lasts, or do not allow exclusion or limitation of incidental or consequential
damages, so these limitations may not apply to you.
To obtain service under this warranty, you must:
-
Send written notice of the claimed condition to The Outdoor GreatRoom Company, 14400 Southcross Drive
Suite #100, Burnsville, MN 55306. -
Affirm that you are the original owner of the Product.
-
Provide The Outdoor GreatRoom Company a reasonable opportunity to investigate the claim, including
a reasonable opportunity to inspect the Product prior to any repair or replacement work and before the Product or any component of the Product has been removed.