CLYTON POWER LPS II 3000 – 2 kWh Lithium Power Supply User Guide
- June 13, 2024
- CLYTON POWER
Table of Contents
Operating the LPS II-power supply with the remote
LPS II 3000 – 2 kWh Lithium Power Supply
Using 12 V
Push the button which will light up green, now 12 V is active. Using 230 V
Push the button which will light up green, now 230 V is active. Jump start
LPS- Power Supply can jump start a dead battery. Status
At the lower part of the remote a status indicator gives the charging status.
Status is for both the LPS as well as any additional batteries connected. If
there is no consumption for 60 minutes the 230 V switches off automatically in
order to save power.
230 V is active during driving if there is a key wake-up function and is
automatically switched off after 60 minutes in case there is no consumption.
- Switch the ignition on.
- Push the button which will flash green for 5 minutes.
- After 5 min. the LED diode stops flashing – now the car will start.
In case of malfunction
- Check if the RCD-relay is active
- Check battery status
When contacting your supplier
State the serial number which can be found on the side of the RCD-relay State possible error code
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>