THE OUTDOOR GREATROOM COMPANY Key Largo Linear Gas Fire Pit Instruction Manual
- June 9, 2024
- THE OUTDOOR GREATROOM COMPANY
Table of Contents
THE OUTDOOR GREATROOM COMPANY Key Largo Linear Gas Fire Pit
Required Tools
-
Utility Knife
To cut and remove packaging -
2 Open Ended Wrenches
To make gas connections -
Leather Gloves
To protect hands from rough edges found on the coffee table. -
One (1) AAA Battery (not included) Required for piezoelectric igniter installation.
-
It is recommended that a minimum of two people assemble and install fire pit tables.
Assembly Instructions
- Remove access door from packaging
- Remove all components from packaging.
- Move the base without door to desired location and set into place.
- When locating your coffee table, refer to the Crystal Fire® Plus manual and maintain clearance to combustibles.
- Assemble as shown below.
Igniter Installation
- Sparker must be installed before burner valve.
- Unscrew sparker cap and hex nut. Install as shown below.
- To properly install ignition system, a spark and ground wire need to be attached to the igniter box.
- Plug both black wires hanging from the bottom of the burner into the sparker box.
- Test system by pushing the button on the ignitor, look and listen for a solid spark at the electrode on the burner surface. Consult troubleshooting section if spark is faint or intermittent.
- Once ignition system is grounded and gas connections are secured and checked for leaks, set the burner back into its original position and replace the top if applicable.
Gas Connection
Read and understand your Crystal Fire® Plus owner’s manual before beginning burner hookups or using the
- See Crystal Fire® Plus instructions for burner installation.
- All Gas connections were completed at the factory.
- Check all connections for leaks. If needed, tighten connection with 2 wrenches and re-check for leaks.
Locating your Tank
- Tilt your propane tank into the slide out tank drawer.
- With the propane tank and control valve in the OFF position, connect the Regulator Hose, included with the Crystal Fire® Plus Burner, to your propane tank (not included). Hand tighten connection, do not use tools to tighten this connection.
- Slide tank drawer in. Ensure that the Gas hose does not get pinched in the process of sliding the tank drawer.
NOTE: Over time the bearings in the door glides may require re-greasing. Any spray lubricant, such as WD-40, may be used to lubricate drawer glides. Perform annually or on an as needed basis to maintain smooth operation.
Gas Line Location
If the fire pit is to be supplied by natural gas or a hard piped propane
system, locate your plumbing outside of the area of the tank drawer. Gas can
be stubbed up within the green area indicated below.
Finishing touches
Once fire pit is set up and in the desired position, scatter decorative glass on burner surface forming an even layer of beads.
- DO NOT BURN WIT HOUT GLASS OR OTHER APPROVED DECORATIVE FIRE MEDIA
- DO NOT BURN WITH GLASS COVER INSTALLED
IMPORTANT
Please consult your Crystal Fire® Plus instruction manual for detailed
instructions and important information related to hooking up your linear
burner, including safety information, proper tightening of connections with
two wrenches and full burner setup and lighting instructions.
DO NOT ATTEMPT TO INSTALL CFP1242 BURNER WITHOUT FIRST CONSULTING THE CRYSTAL
FIRE® OWNER’S MANUAL.
WARNING After consulting the manual and following instructions, remember; before operating, all gas connections must be fully checked for leaks
Thank you for purchasing an Outdoor GreatRoom Company product! This fire pit was made with pride in the USA.
Warranty
Warranty: Fire pit tables are covered under a 1-year manufacturer’s
warranty. Please visit
http://www.outdoorrooms.com/product-registration to register your product.
© 2014 The Outdoor GreatRoom Company
9583 217th St. W. • Lakeville, MN 55044
Toll Free: 1-866-303-4028 •
Sales@OutdoorRooms.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>