THE OUTDOOR GREATROOM COMPANY GWMT-60 Gallery and Modern Mantels Instruction Manual

June 3, 2024
THE OUTDOOR GREATROOM COMPANY

THE OUTDOOR GREATROOM COMPANY GWMT-60 Gallery and Modern Mantels

THE OUTDOOR GREATROOM COMPANY GWMT-60 Gallery and Modern Mantels-
fig1

Required Tools

  • Two or more people are required for this installation

  • Power Drill with Phillips bit
    For fastening the mantel to wall surface

  • Leather Gloves
    To protect hands from rough edges on concrete

  • Utility Knife
    To cut and remove packaging

  • Level
    To ensure mantel is parallel to floor

  • Tape Measure
    For locating and centering mantel

  • Stud Locator
    For locating studs inside a finished wall

  • Pencil
    For marking stud locations

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
When using the furnishing, basic precautions should always be followed, including the following:

  • Read all instructions before mounting or using the mantel
  • Use the furnishing only for its intended use as described in these instructions.

IMPORTANT
The fasteners supplied with this furnishing are intended for use in standard wood stud walls only . Minimum wall stud size required is 2”x 4”, with drywall or finished wall surface ranging from ½” to ¾” thick. For all other mounting surfaces, use appropriate fasteners as specified by local building codes or other jurisdiction. For mounti ng to other wall types; if you are at all unsure of the correct fastening method, contact your local building official. Improper mounting may lead to property damage, injury, or death.

DO NOT OVERLOAD MANTEL:

  • THE MAXIMUM LOAD FOR ALL 60 INCH MANTELS is 150lbs. MAXIMUM LOAD FOR ALL 72 IN CH MANTELs is 180lbs.
  • MANTEL “SUPERCAST” MATERIAL MEETS NON COMBUSTIBILITY STANDARDS IN ACCORDANCE WITH ASTM E136.

Warning !
Combustible objects placed on or around the mantel must meet your fireplace manufacturer’s requirements for clearances to combustibles.

Included in this kit

(Various Models Shown)
*Dimensions may vary slightly (by up to ½”) due to the mantel being molded from real rough-cut cedar beams.

THE OUTDOOR GREATROOM COMPANY GWMT-60 Gallery and Modern Mantels-
fig2
THE OUTDOOR GREATROOM COMPANY GWMT-60 Gallery and Modern Mantels-
fig3

Mounting Instructions

  • Check for damage. Do not use damaged components.
  • It is required to mount the unit at wall stud locations (if applicable) for proper holding strength and weight distribution.
  • Be sure to follow your fireplace manufacturer’s clearances to non-combustibles or local code if applicable when determining a location for your mantel. Combustibles set on a non-combustible mantle must meet clearance requirements for combustibles.
  1. Choose a location for your mantel and locate studs behind the wall surface using a stud locator. Mark stud locations with a pencil for reference in the next step.

  2. Hold the Hanging Bracket up to the wall surface, centered at the desired location, and ensure it is parallel to the floor using a level.

  3. Use a pencil to mark hole locations on the bracket, lining it up with a minimum of 3 studs.

  4. Insert the supplied #8 x 2-1/2” Wood Screws at the marked hole locations, two screws per stud location as shown below.

THE OUTDOOR GREATROOM COMPANY GWMT-60 Gallery and Modern Mantels-
fig5

  1. With two people, one lifting from each end, lift the mantel up so that the top edge of the bracket is approximately centered in the cavity at the back side and hold flush to the wall surface. Carefully lower on to the hanging bracket and ensure the mantel is seated properly before placing the full weight of the mantel on the bracket.

THE OUTDOOR GREATROOM COMPANY GWMT-60 Gallery and Modern Mantels-
fig6

Care and Maintenance

To keep your mantel looking new, we recommend the following:

  • Minor surface scratches can be removed by re-sealing with SC-SEALER (Available for sale by the Outdoor GreatRoom Company)
  • If any colored liquids such as wine or soda are spilled on your mantel, clean off immediately to avoid possible staining.
  • We recommend dusting your mantel regularly and cleaning with a mixture of mild dish detergent and warm water; rinse thoroughly.
  • We recommend sealing your mantel as needed. If the surface begins looking dull, clean and re-seal with SC-SEALER available through the Outdoor GreatRoom Company.
  • All mantels arrive pre-sealed with a solvent-based sealer.

Warranty:

Supercast Mantels are covered under a  1-year manufacturer’s warranty. Please visit http://www.outdoorrooms.com/product-registration to register your product.
Thank you for purchasing an Outdoor GreatRoom Company product! This product was made with pride in the USA.

ABOUT COMPANY

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

THE OUTDOOR GREATROOM COMPANY User Manuals

Related Manuals