VOWEEK VW-HT02 Space Heater User Manual
- June 15, 2024
- Voweek
Table of Contents
SPACE HEATER
VW-HT02 User Manual
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USE AND SAVE FOR FUTURE REFERENCE
When using an electrical appliance, especially when children are present,
basic safety precautions should always be followed, including the following
DANGER!
- DONOT partially or fully cover or obstruct the front of this heater.
- DO NOT touch or hold the mains plug with wet hands.
- DONOT touch hot surfaces with bare hands. Use handles when moving the unit.
INTENDED USE
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by person responsible for their safety.
- Extreme caution is necessary when any heater is used near children, pets or the disabled. NEVER leave the heater unattended while operating.
- Suitable for dry locations only. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never place the heater where it may fall into a bathtub or other water container.
- Do not use or store where it may get wet or in the immediate surroundings of a bath, a shower, or a swimming pool.
- It is NOT intended for industrial or commercial use. Do not use outdoors.
- Use the appliance only for intended household purposes as described in this User Manual.
EL ECTRICITY SAFETY
- This appliance must be provided with correct voltage via a profes— sionally installed power socket. Make sure the voltage indicated on the label of the appliance is the same as your local supply.
- DO NOT operate the heater with a damaged cord or plug or if the product malfunctions, is dropped or damaged in any manner.
- Always plug heaters directly into a wall outlet / receptacle. Never use with an extension cord or relocatable power tap (outlet / power strip).
- To prevent overload and blown fuses, be sure that no other appliance is plugged into the same outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
IMPORTANT – This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electric shock, this plug is intended to fit
in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to rig this safety feature.
RELATED TO USE
- DO NOT attempt to disassemble, repair, modify or replace any part of your product. All servicing should be performed by qualified personnel only.
- DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic areas and where it will not be tripped over. To avoid fire hazard, NEVER route cord under furniture or appliances.
- DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause electric shock, fire or damage to the heater.
- The heater has hot or arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored.
- Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 meters) from the front and top of the heater and keep them away from the sides and rear.
- Always make sure to place the heater on a flat, level and secure surface before operation.
- Always turn the heater OFF and unplug it before cleaning, making any repairs or servicing, or whenever not in use.
It is normal that there is a trace of smoke or odor when using it for the first time. It will quickly evaporate and should not re-occur.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
EXPLORING YOUR SPACE HEATER
Specifications
Input | 120V~ 60Hz |
---|---|
Rated Power | 1500W |
In The Box | 1x Heater Body, 1x Base, 3x Thumbs Screws, |
1x Remote Control (Batteries not included)
Assembling Your Space Heater
**** Make sure that space heater is properly installed before plugging into
an electrical outlet.
-
Unscrew the 3 thumb screws (attached to the body bottom) counterclockwise.
-
Align the pegs with slots on the body. Secure the assembled base to the body by tightening the 3 thumb screws in the screw holes.
Control Panel
LED Display
USING YOUR SPACE HEATER
**Make sure the heater is placed on a firm, level surface free from
obstructions, and atleast 3ft. (0.9m) away from any wall or combustible
material.
Control Functions**
| ECO Mode/Temperature Setting
- With unit on, press once to turn on ECO Mode. Keep pressing to set desired temp (41~95°F)
- Once the set temp is reached, the heater will stop heating.
It will start again when the temp drops to 2°F below the setone.
---|---
| °F/°C Conversion - With unit on, hold and simultaneously for 2s to convert the temperature unit.
| Heating Mode - With unit on, press to cycle through High (HI) and Low (LO) modes.
- Temperature cannot be adjusted under Hl or LO mode.
| Power ON/ OFF - Press once to turn ON (HI by default).
- Press once again to turn OFF (Standby mode) with 15s countdown delay.
| Auto-off Timer Setting - With unit on, press to set timer for turning off the heater (0-12H).
- To cancel, hold for 3s, or set timer to 0, or turn the unit off.
| Oscillation - With unit on, press to start / stop oscillating.
Additional Features
Auto Display OFF| If no operation is done within 30s after powered on, only
Power Indicator stays on (50% brightness) display.
Press any button to wake the display up.
---|---
Tip-Over Protection| When the heater is tipped over, it will shut off
automatically.
Place the heater back on a flat, level surface and remain upright. Then turn
it on again.
24-Hour Auto OFF| After 24 hours of continuous use, the heater will turn off
(standby mode) automatically.
Overheat Protection| When the ambient temperature is above 122°F, the heater
will stop heating with beeps.
Unplug and wait for the temp to drop below 122°F before turning it on again.
Memory Function| If power is not disconnected, it will always
remember your last settings (except timer) when turned back on.
Using with Remote Control
** For added convenience, the same control buttons can be found on the
remote control. Effective range: 16 ft. /5 m. Replacing Remote Battery
**
- Replace with new batteries of the same type (AAA Alkaline) when necessary.
- When not using the remote control for extended period of time, take out the batteries,
- DO NOT attempt to dismantle the batteries.
- DO NOT dispose the batteries in fire, batteries may explode or leak
- Remove the battery box cover along the indicated arrow.
- Replace with two new AAA alkaline batteries, making sure the “+ and “-” polarities match.
- Reinstall the cover into place.
CARE AND CLEANING
- Always make sure the heater is turned off and unplugged before cleaning.
- DO NOT stick any foreign objects or your fingers inside of the unit.
- Never immerse in water or allow water to drip into the motor housing.
Outer Surface
Turn the heater OFF, unplug and wait for it to cool down. Wipe the surface
with a soft, dry cloth only.
Air Inlet & Outlet Grills
Clean dust between the grills with a vacuum cleaner or air duster.
Storage
Cover and store in a cool, dry location with the cord arranged away from
traffic areas to avoid trip-over or damage.
TROUBLE SHOOTING
The troubleshooting guide addresses the most common problems. If problems persist, feel free to contact the Customer Support at support@voweek.com.
Problem | Solution |
---|---|
My heater does not start. | Check if the heater is properly connected to a |
powered electrical outlet and the voltage indicated is the same as your local
supply.
Make sure the temperature you set is higher than the ambient temperature.
My heater stops heating suddenly.| When the set temperature is reached, the
heater will stop heating. It will resume working again when the ambient temp
is lower than the set one.
Check if you have enabled Auto-OFF timer.
Tap the power button to turn it on again.The heater is tipped over and shut of
f automatically. Place it back on a flat, level surface and remain upright.
Then turn it on
again.
The ambient temperature is above 122°F, unplug and wait for the temp to drop
below 122°F before turning it on again.
The heater will turn off automatically after 24 hours of continuous use.
WARRANTY AND SERVICE
Thank you for choosing VOWEEK Space Heater. This product is covered with
VOWEEK product and labor warranty for 12 months from the date of its original
purchase.
The warranty will not apply in cases of:
Accident, misuse, or repairs performed by unauthorized personnel.
– Any unit that has been tampered with or used for commercial purpose.
– Normal wear and tear of wearable parts.
– Use of force, damage caused by external influences.
– Damage caused by non-observance of the User Manual, e.g. connection to an
unsuitable mains supply or non-compliance with the instructions.
– Partially or completely dismantled appliances.
– Defects caused by or resulting from damages from shipping or from
repairs, service, or alteration to the product or any of its parts that have
been performed by a repair person not authorized.
We can only provide after sales service for products that are sold by VOWEEK
or VOWEEK authorized retailers and distributors. If you havepurchased your
unit from a different place, please contact your seller for return and
warranty issues.
- Please have your invoice and order ID ready before contacting Customer Support.
Questions or Concerns?
support@voweek.com
Manufacturer: Shenzhen Guiyang Network Technology Co., Ltd
Address: 1404K3, East Block, Shengtang Commercial Building,
Futian District, Shenzhen, China
Made In China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>