RemotePro Installing Receiver to MB-T304 Instructions

RemotePro Installing Receiver to MB-T304

Installing Receiver to MB-T304

1. TURN OFF POWER FROM THE POWER POINT

2. View the diagram below and ensure that it matches with the back of
   your motor.

3. Loosen each of the three screws, 1, 2, 3 on the back of your motor.

4. Connect the black receiver cable to the 1 screw and ghten.

5. Connect the blue receiver cable to the 2 screw and ghten.

6. Connect the brown receiver cable to the 3 screw and ghten.

7. Turn power back on and ensure the receiver powers up.

8. Your two new remotes have been pre-programmed to the receiver.
   Press buon 1 on your new remote to ensure it can operate the door.

Note: Please ensure your motor looks like the image below

Coding new remotes

Please Note: Your original remotes will connue to work

1. Press the black learn buon inside the receiver located next to the LED light unl the LED illuminates.
2. Press and hold any buon on your new remote unl the LED flashes 3 mes.
3. The remote is now coded, please test the remote to ensure it can operate the motor.
4. If you have more than one new remote, please repeat steps 1-3.

WARNING

• To prevent possible SERIOUS INJURY or DEATH:
  – Battery is hazardous:NEVER allow children near batteries.
  – If battery is swallowed, immediately notify a doctor.

• To reduce risk of fire, explosion or chemical burn:
  – Replace ONLY with the same size and type battery
  – DO NOT recharge, disassemble, heat above 100° C or incinerate

• Battery will cause SEVERE or FATAL injuries in 2 hours or less if swallowed or placed inside any part of the body.

www.remotepro.com.au

Documents / Resources

| RemotePro Installing Receiver to MB-T304 [pdf] Instructions
RemotePro, Installing, Receiver, to, MB-T304
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>