RemotePro Installing Receiver to Aussie Opener Garage Door Motor Installation Guide
- June 6, 2024
- RemotePro
Table of Contents
RemotePro Installing Receiver to Aussie Opener Garage Door Motor
1. TURN OFF POWER OF MOTOR FROM THE POWER POINT
2. View the diagram below and ensure that it matches with the back of your
motor.
3. Connect the black receiver cable to the PB.
4. Connect the blue receiver cable to GND.
5. Connect the brown receiver cable to +24.
6. Turn power back on and ensure the receiver powers up.
7. Your two new remotes have been pre-programmed to the receiver.
Press button 1 on your new remote to ensure it can operate the door.
Please Note: Your original remotes will continue to work
1. Press the black learn button inside the receiver located next to the LED
light until the LED illuminates.
2. Press and hold any button on your new remote until the LED flashes 3 times.
3. The remote is now coded, please test the remote to ensure it can operate
the motor.
4. If you have more than one new remote, please repeat steps 1-3.
www.remotepro.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>