logitech G703 Lightspeed Wireless Gaming Mouse Installation Guide
- June 6, 2024
- Logitech
Table of Contents
G703
LIGHTSPEED Wireless Gaming Mouse
Souris gaming sans fil LIGHTSPEED
SETUP GUIDE
| GUIDE D’INSTALLATION
SETUP INSTRUCTIONS
1 A wireless receiver, USB adapter, and optional 10g weight can be found in the packaging Plug one end of the cable into your PC, and the other end into the USB adapter and receiver – The receiver can also be used plugged directly into your PC However, using the cable and adapter when in wireless mode is recommended and allows for better connectivity and easy access to the cable for recharging
2 Turn mouse on via the switch on the bottom of the mouse
3 To charge, disconnect the cable from the adapter and plug it into the front of the mouse Your mouse will operate in data‑over‑cable mode whenever it is plugged in directly to a PC Full charge from empty requires approximately two hours plugged into a PC USB port
Tips:
– Keep the mouse and receiver 2 m+ away from wireless routers or other 2 4GHz
wireless devices to minimize environmental noise
– G703 has a wireless range of up to 10 meters To ensure optimal performance
in noisy wireless environments, and to keep the charging cable easily
accessible, it is recommended to keep the receiver within 20 cm of the mouse
MOUSE FEATURES
- Left (Button 1)
- Right (Button 2)
- Wheel click (Button 3)
- Back (Button 4)
- Forward (Button 5)
- DPI Cycle
- On/Off switch (bottom of the mouse, not programmable)
- Weight door
WIRELESS BATTERY LIFE
G703 has a rechargeable 720mAh LiPol battery which provides it with up to 32
hours of non‑stop gaming at 1ms report rate with lights off, or 24 hours
non‑stop gaming at 1ms report rate with RGB color cycling on *
– Charge level can be checked when the mouse is powered on or using Logitech
Gaming Software to assign a button to check the charge level
– Charge level is displayed for seven seconds at mouse power‑on using the
color of the scroll wheel
– Green = 50–100%
– Orange = 30–50%
– Red = 15–30%
– Flashing red = <15%
Tip : You can program a button to show charge level using LGS
– The scroll wheel will flash red when the battery is at 15% or less When this
happens, plug in your mouse to charge
– Charge level, power draw, and estimated remaining battery life can be
checked in Logitech Gaming Software
• Battery life and capacity may vary with age and use Rechargeable batteries
have a limited number of charge cycles
CHARGING/DATA OVER CABLE
Plug your mouse in via the provided USB charging cable when the battery is low The mouse will seamlessly swap to data-over-cable mode whenever it is plugged in G703 is also compatible with the Logitech G POWERPLAY wireless charging system, sold separately
RGB PROGRAMMABLE LIGHTING
G703 wheel and logo is illuminated with RGB LEDs These colors can be
customized using Logitech Gaming Software to a variety of breathing, color
cycling, or solid color modes Lighting patterns can also be synchronized with
other supported Logitech G devices using this software 
LOGITECH GAMING SOFTWARE
You can customize the 3 onboard profiles of the G703 using the Logitech Gaming
Software These settings include surface tuning, button programming, lighting
color, lighting effects, report rate, and tracking behavior G703 allows up to
5 DPI settings per profile By default, G703 has 1 active onboard profile with
the following settings:
– DPI: 400, 800, 1600, 3200
– RGB lighting: color cycle
– Report rate: 1ms
QUESTIONS
http://support logitech
com/product/g703
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>