Tenda TEF1106P-4-63W, TEF1110P-8-63W 6 Port 10M 100M Desktop Switch Installation Guide
- October 27, 2023
- Tenda
Table of Contents
TEF1106P-4-63W, TEF1110P-8-63W 6 Port 10M 100M Desktop Switch
Installation Guide
Package contents
- Switch *1
- Power adapter * 1
- Quick installation guide* 1
Connecting your devices
TEA 106P-4-63W is used for illustration.
Tips:
- The switch supports the auto MDI/MDIX function, indicating that either straight cables or crossover cables are acceptable to connect your switch to Ethernet devices.
- To protect the switch from overload, PoE ports of your switch are assigned with power supply priorities, and the priorities decrease as the port number increases. When the total power consumption of the PoE-powered devices exceeds the maximum output of the switch, the switch starts cutting the power supply from the port with the lowest priority, until the total consumption does not exceed the maximum output.
- Port 1 and 2 own a higher priority. You are recommended to connect them to the network devices (IP cameras or APs) in key area, to ensure a higher priority for data transmission when network congestion occurs.
- For safety, do not face the air vents of the switch down when you use wall mounting.
| LED indicator/Toggle | Status | Description |
|---|---|---|
| Link/Act | Solid on | The corresponding port is connected properly. |
| Blinking | Data is being transmitted over the corresponding port. | |
| Off | The corresponding port is disconnected or improperly connected. | |
| PWR | Solid on | The switch is connected to a power source properly. |
| Off | The switch is disconnected from a power source or not properly connected |
to a power source.
Mode selection toggle| Default| In this mode, all ports of the switch can
communicate with each other
separately.
Extend| In this mode, the maximum data rate of each PoE port reduces to 10
Mbps,
but the maximum transmission distance increases to 250 meters.
ForTEF1110P-8-63W, the PoE ports can communicate with the uplink port
and NVR port, but cannot communicate with each other.
Specifications
| M.1.4 | TEF1106P-4-63W | TEF I 1 10P-8-63IV |
|---|---|---|
| Interface | loam Mbps R.145 port | 6 |
| Working mode | Default: In this mode, all ports of the switch can communicate |
with each other separately.
Extend: In this mode, the maximum data rate of a single PoE port reduces to 10
Mbps, but maximum transmission distance is 250 meters. For TEFI110P-8-63W, the
PoE ports can communicate with uplink port and NVR port, but cannot
communicate with each other.
i ure| Store-and-forward| Supported
MAC address table| 1 K
MAC address learning| Self-learning, auto-aging
Backplane bandwidth| 1.2 Gbps| 1.6 Gbps
PoE power supply| PoE standard| IEEE 802.3af, IEEE 802.3at
PoE port| 1 to 4| 1 to 8
Maximum output of a single port| 30W
Maximum output of the switch| 58W
PoE power cable core| 8 cores:voltage of cores 1, 2, 4, 5 is +, and cores 3,
6, 7, 8 is -.
Lightning protection| R.145 port| Common mode: 6 kV (Uplink port, NVR port)
Power supply| Common mode:4 kV Differential mode:2 kV
Environment| Operating environment| Temperature: (0 -45rC
Humidity: (10% – 90%) RH, non-condensing
Storage environment| Temperature: (-40-70)°C
Humidity: (5%- 90%) RH, non-condensing
Power adapter| Input voltage| 100-240V AC 50/60Hz 1.5A
Output voltage| 51 V 1.25A
Dimension| 100 mm. 100 mm26 mm| 177.5 mm 104 mm.26 mm
Transmission data rate| Ethernet: 10 Mbps(half-duplex)/20 Mbps (full-duplex)
Fast Ethernet:100 Mbps (half-duplex)/200 Mbps (full-duplex)
Transmission media| Ethernet: CATS UTP/STP cable or better
Fast Ethernet: CATS UTP/STP cable or better
Standards| IEEE 802.3,IEEE 802.3u, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
CE Mark Warning
This is a Class A product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures. The mains plug is used as disconnect device; the disconnect device
shall remain readily operable.
NOTE:
- The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
- To avoid unnecessary radiation interference, it is recommended to use a shielded RJ45 cable.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense. Operation is subject to the following two
conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Caution! Any changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate the
equipment.
NOTE:
- The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
- To avoid unnecessary radiation interference, it is recommended to use a shielded RJ45 cable.
RECYCLING
This product bears the selective sorting symbol for Waste electrical and
electronic equipment (WEEE). This means that this product must be handled
pursuant to European directive 2012/19/EU in order to be recycled or
dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization
or to the retailer when he buys a new electrical or electronic equipment.
Caution:
Adapter Model: BNO31-A65051
Manufacture: SHENZHEN HEWEISHUN NETWORK TECHNOLOGY CO., LTD.
In p ut: 100 -240 V AC 50/60 Hz, 1.5 A
Output: 51 V, 1.25 A
DC Voltage
Technical Support
Shenzhen Tenda Technology Co., Ltd
6-8 Floor, Tower E3, NO.1001, Zhongshanyuan Road, Nanshan District, Shenzhen,
China. 518052
USA hotline:1-800-570-5892
Toll Free: Daily-9am to 6pm PST
Hong Kong Hotline: 00852-81931998
Global Hotline: +86 755-2765 7180 (China Time Zone)| Canada
hotline:1-888-998-8966
Toll Free: Mon- Fri 9 am- 6 pm PST
Website: www.tendacn.com
E-mail: support@tenda.com.cn
---|---
Copyright
Copyright© 2019 Shenzhen Tenda Technology Co., Ltd. All rights reserved.
Tenda is a registered trademark legally held by Shenzhen Tenda Technology
Co., Ltd.
Other brand and product names mentioned herein are trademarks or registered
trademarks of their respective holders.
Specifications are subject to change without notice.
Documents / Resources
|
Tenda TEF1106P-4-63W, TEF1110P-8-63W 6 Port 10M 100M Desktop
Switch
[pdf] Installation Guide
TEF1106P-4-63W, TEF1110P-8-63W 6 Port 10, 100M Desktop Switch with 4 Port PoE
10 Port 10, 100M Desktop Switch with 8 Port PoE, TEF1106P-4-63W TEF1110P-8-63W
6 Port 10M 100M Desktop Switch, 6 Port 10M 100M Desktop Switch, 10M 100M
Desktop Switch, Desktop Switch, Switch
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>