Mi-Light 4-Zone RGB+CCT Remote Controller FUT092 Instruction Manual
- June 6, 2024
- Mi-Light
Table of Contents
4-Zone RGB+CCT Remote Controller ( FUT092 )
User Instruction
Features
This product adopts a worldwide used 2.4GHz frequency, GFSK control method, with the features of low power consumption, long distance transmitting, strong anti-interference, and fast communication rate; can control specified Mi-Light smart light with color, color temperature, saturation, and brightness changes.
Parameters
Model No.: FUT092 | Transmission Frequency: 2.4GHz |
---|---|
Voltage: 3V(2*AAA battery) | Modulation Method: GFSK |
Power Consumption: 6dBm | Control Distance: 30m |
Standby Power Consumption: 20uA | Size: 138mm56mm20mm |
Instruction
- Long press “Master OFF ” or “Zone OFF” to night light mode.
- Touch “Color temperature line” to white light mode and adjust color temperature.
- Touch “Color Ring” to change the colors.
- Press “Speed+” to accelerate the dynamic mode speed continuously until to the fastest speed.
- Press “Speed-” to lower the dynamic mode speed continuously until to the lowest speed.
The light can be working after linking with the remote controller.
Linking Instructions
| |
---|---|---
1. Switch off the light, after 10 seconds switch on again| 2. When the
light on, short press any zone of “ ” 3 times within 3 seconds| 3. The
light blinks 3 times slowly means the linking is done successfully.
If the light does not blink slowly, the linking failed, Pls switch off the light again, and follow the above steps again.
Unlinking Instructions
| |
---|---|---
1. Switch off the light, after 10 seconds switch on again| 2. When the
light is on, short press ” ” 5 times within 3 seconds.
Unlinking must be the same zone with the Linking| 3The light blinks 3
times slowly means the linking is done successfully.
If the light does not blink quickly, the unlink failed, pls switch off the light again, and follow the above steps to unlink again.
Caution
-
Remote controller only controls specified Mi-Light products; not all Mi-Light series can work on this remote controller.
-
In the use of the remote, if the indicated lamp blinking quickly, pls change the battery in time.
Pls, don’t use poor-quality batteries to avoid the leaking of battery liquid to damage the remote controller. -
Pls don’t use the remote controller on the wide-range metal or strong electromagnetic wave area, otherwise, it will badly affect the controlling distance.
Made in China
Documents / Resources
| Mi-
Light 4-Zone RGB+CCT Remote Controller
FUT092
[pdf] Instruction Manual
Mi-Light, 4-Zone, RGB CCT, Remote Controller, UT092
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>