kinderkraft GRANDE 2020 Strollers User Manual

: October 27, 2023
: Kinderkraft

Table of Contents

Safety and care notes
ASSEMBLY
Warranty
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

kinderkraft GRANDE 2020 Strollers

Dear Customers,

Thank you for purchasing a Kinderkraft product. Our products have been designed for your child’s safety and comfort. The buggy is an ideal solution for those who value quality, modernity and functionality. Please read the manual carefully and follow its recommendations.
IMPORTANT – READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.

Safety and care notes

WARNING!

Never leave the child unattended.
Ensure that all the locking devices are engaged before use.
To avoid injury ensure that the child is kept away when unfolding and folding this product.
Do not let the child play with this product.
Always use the restraint system.
Check that the pram body or seat unit or car seat attachment devices are correctly engaged before use.
This product is not suitable for running or skating.
Age and weight usage: from 0 months up to 15 kg.
We recommend using lowest reclined position for newborn babies.
This product may only be used by one child at the same time
The parking device shall be engaged when placing and removing the children
The maximum basket load is 2 kg.
Maximum weight of a bag attached to the adjustable handle is 1 kg.
Any additional load suspended from the buggy handles, backrest and sides will cause stability loss.
Use only parts and accessories supplied or recommended by the manufacturer. Do not use other parts or accessories.
Lift the front suspension when going up a curb or step.
Do not place the product near open flame or other heat sources.
Do not use with an additional platform.

ASSEMBLY

I. BUGGY COMPONENTS (FIG. 1)

A. Frame with seat and safety straps
B. Front wheels
C. Rear wheels
D. Safety bar
E. Cup holder
F. Leg cover
G. Rain cover
II. UNFOLDING BUGGY FRAME Place the frame on a flat surface with its handle up (FIG. 2). Start unfolding the Baby stroller by pressing the parents’ handle against the Baby stroller frame so that all the elements are tightly connected (Fig. 2, A), then press the button on the parents’ handle (I) and press the big button (II) as shown in Fig. 2, B. Pull the baby stroller frame upwards until it locks. Make sure that the buggy cover is properly attached to the Velcro fasteners on both sides of the buggy (FIG. 3).
NOTE! Make sure that the attachments on the inner side of the buggy material are inserted into the hooks, and the press studs are closed (FIG. 16). A properly unfolded frame is shown in FIG. 4.

III. WHEEL ASSEMBLY/DISASSEMBLY Insert the rear wheels in the rear axles holes until you hear the locking sound (FIG. 5). In order to remove the rear wheels (FIG. 6), unlock the locking button located on both sides of the rear axle (6A) while pulling the wheels out of the slots (6B). Insert the front wheels in the front axles until you hear the locking sound (FIG. 7). To remove the front wheels, push the quick release button located below the footrest under each wheel (FIG. 8). The buggy has a system of swivel front wheels which can be locked in the straight-ahead position. To lock the wheel to move forward, slide the ring located above the wheel (FIG 9)

NOTE! Before using the buggy, make sure that all the wheels are properly installed.

IV. ASSEMBLY/DISASSEMBLY OF THE SAFETY BAR AND LEG COVER, CANOPY ADJUSTMENT The safety bar must be inserted in appropriate slots on both sides of the frame, as shown in Figure 10. To remove the bar, press the buttons on both sides and remove the bar (FIG. 11). Leg cover has four Velcro fasteners located on the inner side. In order to attach the cover, fasten the Velcro fasteners on the seat frame tubes. To adjust and unfold another layer of material, unfasten the zip located on the canopy (FIG. 12A and 12B).

V. USE OF BRAKE The buggy is equipped with a foot brake located on the rear axle. Press the lower part of the brake down; the brake is activated when you hear the locking sound (FIG. 13). Unlocking occurs after lifting the lower part of brake lever.

VI. BACK AND FOOTREST ADJUSTMENT AND CUP HOLDER ASSEMBLY (FIG. 14) The seat is equipped with smooth backrest adjustment system, from a lying to a sitting position, using a clasp (14A). The footrest has 3 positions. Press the buttons on both sides (14B) to change the footrest position. Cup holder is mounted on the left side of the buggy on the stem (14C).

VII. SAFETY STRAPS (FIG. 15) The buggy’s straps are adapted in such a way to enable its use even by newborns. Always use the fastening system. To secure the child, connect the latches of the hip and shoulder straps (15A) and then insert them into the middle clasp until it engages (15B). Adjust the straps each time. Removing the straps (for cleaning): Take the shoulder and hip straps out of the openings.

VIII. SEAT COVER REMOVAL Remove the safety straps and safety bar. To remove the cover from the seat (FIG. 16), unfasten the press studs located on the buggy frame (16A) and take the cover off the hooks located next to it (16B). Then release the Velcro fasteners on the sides of the buggy and under the seat and pull the two straps attaching the seat to the frame out of the plastic clasps (FIG. 17). Note! In order to clean/wash the seat, remove all seat reinforcing pads attached by Velcro fasteners in the two seat parts. Install the seat following the steps described above in reverse order. NOTE! Pull the straps fastening the seat through the two clasps, and then put the end of the strap between the two clamps and tighten (FIG. 18).

IX. FOLDING THE BUGGY When folding the buggy, lower the backrest as far as possible, activate the brake. To fold the frame, press the lock button (Fig. 19.I) located on the handle simultaneously pressing the folding button ( Fig.19.II) and push the handle down ( Fig.20).

X. CARE AND MAINTENANCE The buyer is responsible for proper installation of all functional elements as well as for carrying out all required maintenance and adjustments in order to keep the buggy in good technical condition. The buggy must be periodically checked for potential problems. Significant measures to be applied to ensure the child’s safety and prevent shortening of the product life have been presented below:

Check the strength and safety of all rivets and connections.
Check all wheel locking equipment and tyres. If necessary, replace or repair.
Check if all safety devices work properly, particularly the main and additional fasteners that should move freely at any time.

If the wheels squeak, apply a thin layer of silicone. Do not use oil or grease based products as they attract dirt, which makes buggy movement difficult.
XI. CLEANING

| Wash at max. 30°C, gentle process| | Do not wash. Clean the product gently with a damp cloth and a mild detergent.
---|---|---|---
| Do not bleach| | Do not iron
| Do not dry in a tumble dryer| | Do not dry clean

If the elements of the buggy chassis have been exposed to saltwater, rinse with tap water as soon as possible.
Do not fold or store the product when it is wet and never store it in wet conditions, as it can lead to mould growth.

Warranty

All Kinderkraft products are covered by a 24-month warranty. The warranty period starts from the date the product is handed over to the Buyer.
The warranty is only valid in the member states of the European Union, excluding overseas territories (as currently defined, including in particular: Azores, Madeira, Canary Islands, French Overseas Departments, Åland Islands, Athos, Ceuta, Melilla, Helgoland, Büsingen am Hochrhein, Campione d’Italia and Livigno) and the territory of the United Kingdom of Great Britain and Northern Ireland excluding the British Overseas Territories (e.g. Bermuda, Cayman Islands, Falkland Islands).
The manufacturer’s warranty does not apply to countries not listed above. The conditions of the additional warranty may be determined by the Seller.
In some countries, it is possible to extend the warranty to a limited period of 120 months (10 years).The complete terms and conditions and the warranty extension registration form are available at WWW.KINDERKRAFT.COM
The warranty is valid only in the territory indicated in paragraph 2.
Claims must be made by completing the form available at WWW.RMA.KINDERKRAFT.COM
The warranty does not cover:
A. Cosmetic damage, including but not limited to: scratches, dents and cracks in plastic, unless the failure is due to a material or manufacturing defect;
B. Damage resulting from misuse or poor maintenance – including but not limited to: mechanical damage to products caused by misuse or poor maintenance
O Refer to the instructions for use and installation of the product contained in the user manual;
C. Damage caused by improper assembly, installation or disassembly of products and/or accessories;
O. Refer to the instructions for use and installation of the product contained in the user manual;
D. Damage caused by corrosion, mould or rust, resulting from improper maintenance, care and storage;
E. Damage caused by normal wear and tear or otherwise resulting from the normal passage of time;
O This includes: tears or punctures in inner tubes; tyre damage; tyre tread damage; fading of fabrics resulting from mechanical use (e.g. on joints and covering of moving parts);
F. Damage or erosion caused by sun, perspiration, detergents, storage conditions or frequent washing, etc;
G. Damage caused by accident, abuse, misuse, fire, contact with liquid, earthquake or other external causes;
H. Products that have been modified to change functionality without 4Kraft’s written consent;
I. Products from which the serial number or lot number has been removed or tampered with in any way;
J. Damage caused by the use of third party components or products – including but not limited to: cup holders, umbrellas, reflectors, bells;
K. Damage caused by transport or by ground handling service providers.
The warranty period for accessories included with the product is 6 months from the date of sale, excluding the faults described above.
These warranty conditions are complementary to the Customer’s statutory rights with respect to 4KRAFT sp. z o.o. The warranty does not exclude, limit or suspend the Customer’s rights under warranty for defects in goods sold.
The full text of the Terms and Conditions of the Warranty is available on the website WWW.KINDERKRAFT.COM

All rights to the present document belong entirely to 4Kraft Sp. z o.o. Any unauthorized use of them against their purpose, including in particular: using, copying, reproducing, making available – in whole or in part, without the consent of 4Kraft Sp. z o.o. may result in legal consequences.

Kinderkraft.com