POLAR Y8 Stride Sensor Bluetooth Smart Instructions
- June 6, 2024
- Polar
Table of Contents
POLAR Y8 Stride Sensor Bluetooth Smart
This product is compliant with Directives 2014/53/ EU, 2011/65/EU and 2015/863/EU. The relevant Declaration of Conformity is available at www.polar.com/en/regulatory_information.
Canada
Polar Electro Oy has not approved any changes or modifications to this device
by the user. Any changes or modifications could void the user’s authority to
operate the equipment.
Industry Canada (IC) regulatory information
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Class B digital device notice
This Class B digital apparatus complies with Canadian ICES-003, RSS-Gen and
RSS-210.
CNC ID: C-20540
USA
Polar Electro Oy has not approved any changes or modifications to this device
by the user. Any changes or modifications could void the user’s authority to
operate the equipment.
FCC regulatory information
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This product emits radio frequency energy, but the radiated output power of this device is far below the FCC radio frequency exposure limits. This equipment complies with FCC RF radiation exposure limits forth for an uncontrolled environment. Nevertheless, the device should be used in such a manner that the potential for human contact with the antenna during normal operation is minimized.
The main body of this radio equipment labeled the regulatory compliance mark
which had referred to grant the Test or Type Certification in accordance with
Radio Law.
35104/SDPPI/2014 4213
- Frequency 2402-2483.5 MHz
- Maximum power 1.2 mW
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>