Polar GH428 Upright Glass Door Black Display Freezer Instruction Manual

: October 30, 2023
: Polar

Table of Contents

Polar GH428 Upright Glass Door Black Display Freezer
Product Description
Introduction
Pack Contents
Installation
Operation
Set the Operating Temperature
Cleaning, Care & Maintenance
Troubleshooting
Technical Specifications
Electrical Wiring
Disposal
DECLARATION OF CONFORMITY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Polar GH428 Upright Glass Door Black Display Freezer

Polar-GH428-Upright-Glass-Door-Black-Display-Freezer-product-
img Safety Instructions

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.
Consult Local and National Standards to comply with the following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
DO NOT use jet/pressure washers to clean the appliance.
DO NOT use the appliance outside.
DO NOT use this appliance to store medical supplies.
DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.
DO NOT store products on top of the appliance.
Always carry, store, and handle the appliance in a vertical position and move by holding the base of the appliance.
Always switch off and disconnect the power supply to the unit before cleaning.
Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience or knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard.
Polar recommends that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity, and Functional Testing.
Polar recommends that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Warning: Risk of Fire

Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

Warning: Keep all ventilation openings clear of obstruction. The unit should not be boxed in without adequate ventilation.

Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
Warning: Do not damage the refrigerant circuit.
Warning: Do not use electrical appliances inside the food storage compartments of the appliance.

Product Description

GH506/GH428 – Single Door Display Freezer
GH507/GH429 – Double Door Display Freezer

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.

Pack Contents

The following is included:

POLAR Display Freezer
Shelves
Keys x 2
Instruction Manual

POLAR prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your POLAR dealer immediately.

Installation

Note

Not for use in vans or trailers, food trucks, or similar vehicles.
If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before the operation. If in doubt allow to stand.

Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.
To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 20cm clearance on the top.

NEVER LOCATE NEXT TO A HEAT SOURCE

Note: Before using the appliance for the first time, clean the shelves and interior with soapy water then dry well.

Operation

Control Panel
The control panel is located below the doors on the front of the appliance.

Turn On

Close the door of the appliance.
Connect the appliance to a mains power supply.
Turn the light switches On [I] or Off [O] as desired.

Set the Operating Temperature

Press the SET button for 3 seconds. The display will flash.
Press the or buttons to display the required temperature.
Press the SET button to store the temperature.

Storing Food
To get the best results from your POLAR appliance, follow these instructions:

Only store foodstuffs in the appliance when it has reached the correct operating temperature.
Do not place uncovered items as below inside the appliance, as this can lead to a damaged and leaking evaporator, and thus void your warranty: hot food, hot liquids, acidic fluids, and acidic products.
Wrap or cover food where possible.
Do not obstruct the fans inside the appliance.
Avoid opening the doors for prolonged periods of time.

Lock/Unlock the Doors

A lock is fitted to the doors to ensure foodstuffs are kept secure within your POLAR appliance.
Use the keys provided to lock/unlock the door.

Cleaning, Care & Maintenance

Switch off and disconnect from the power supply before cleaning.

Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
Clean the door seal with water only.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
Take care when cleaning the rear of the appliance. Sharp edges can be cut.

Condensation and ice will form with frequent and prolonged opening of the doors. Operating outside of the recommended temperature range and placing next to a heat source will also increase the amount of ice and condensation. Excessive ice will result in longer running times that will increase energy consumption and increase the deterioration of components.

Replacing the Interior Lamp

WARNING: Allow the lamp to cool before replacing. The lamp remains hot immediately after use.

Turn Off and disconnect the appliance from the mains power supply.
Unscrew the plastic lamp cover.
Remove the lamp by twisting it from the lamp sockets.
Insert the new lamp and replace the cover.

Cleaning the Condenser

The condenser is part of the refrigeration system. The condenser requires monthly cleaning.
Always disconnect the power supply before carrying out Routine Maintenance.
Failure to clean the condenser will reduce the performance and life of your Polar unit and may invalidate your warranty.
The condenser is located below the refrigeration cabinet behind a removable panel (see below).
These models have a removable filter that can be cleaned with a vacuum cleaner.

Polar-GH428-Upright-Glass-Door-Black-Display-Freezer-
fig-4

Troubleshooting

A qualified technician must carry out repairs if required.

Fault	Probable Cause	Solution
The appliance is not working	The unit is not switched on	Check the unit is

plugged in correctly and switched on
Plug or lead is damaged| Replace Plug or lead
The fuse in the plug has blown| Replace the fuse
Mains power supply fault| Check the mains power supply
The appliance turns on, but the temperature is too high/low| Too much ice on the condenser| Defrost the appliance
Condenser blocked with dust| Clean the condenser
Doors are not shut properly| Check doors are shut and seals are not damaged
The appliance is located near a heat source or airflow to the condenser is being interrupted| Move the refrigerator to a more suitable location
The ambient temperature is too high| Increase ventilation or move the appliance to a cooler position
Unsuitable foodstuffs are being stored in the appliance| Remove any excessive hot foodstuffs or blockages to the fan
Appliance is overloaded| Reduce the amount of food stored in the appliance
The appliance is leaking water| The appliance is not properly leveled| Adjust the screw feet to level the appliance (if applicable)
The discharge outlet is blocked| Clear the discharge outlet
Movement of water to the drain is obstructed| Clear the floor of the appliance (if applicable)
The water container is damaged| Replace the water container
The drip tray is overflowing| Empty the drip tray (if applicable)
The appliance is unusually loud| Loose nut/screw| Check and tighten all nuts and screws
The appliance has not been installed in a level or stable position| Check installation position and change if necessary
The display lamp does not illuminate| Lamp needs replacing| Replace the lamp

Technical Specifications

Note: Due to our continuing program of research and development, the specifications herein may be subject to change without notice.

Model

|

Voltage

|

Power

|

Current

| Temperature Range|

Refrigerant

| Dimensions H x W x D mm
---|---|---|---|---|---|---
GH507/GH429| 220-240V~

50Hz

| 1000W| 6.0A| -18°C ~ -22°C| R290| 2022 x 1370 x 720
GH506/GH428| 850W| 4.5A| -18°C ~ -22°C| R290| 2022 x 680 x 720

Model

|

Voltage

|

Power

|

Current

| Temperature Range|

Refrigerant

| Dimensions H x W x D mm
GH507/GH429| 220-240V~

50Hz

| 1000W| 6.0A| -18°C ~ -22°C| R290| 2022 x 1370 x 720
GH506/GH428| 850W| 4.5A| -18°C ~ -22°C| R290| 2022 x 680 x 720

Note: For optimal product performance and efficiency, please ensure to mind the net usable capacity (load limit) when filling.

Impact of temperature settings on food waste:

In order to reduce food waste from decomposition or dehydration, this appliance should be operated in its designated operating range.

The optimum temperature for food storage: -18°C

To order spare parts please contact your Polar Stockist:

https://www.polar-refrigerator.com/stockist

|
The minimum period of spares parts to be available:

Door handles, door hinges, knobs, dials and buttons, door gaskets, peripheral trays, baskets, and racks for storage, as appropriate to the appliance, will be made available to both end users and professional users for a minimum of eight years after the last unit of the model is placed on the market. A broader selection of parts will also be made available to Professional users for this period.

Model information can be found on the product database:

https://eprel.ec.europa.eu/screen/product/refrigeratingappliancesdirectsalesfunction

| Polar-GH428-Upright-Glass-Door-Black-Display-Freezer-
fig-6
Model information can be found on the product:

The Model Identifier can usually be found on the inside wall and on the reverse of the unit.

Note: Polar offers a 2-year minimum warranty, please contact the authorized representative for more details.

Electrical Wiring

POLAR appliances are supplied with a 3-pin BS1363 plug and lead.
The plug is to be connected to a suitable main socket.
POLAR appliances are wired as follows:
Live wire (colored brown) to the terminal marked L
Neutral wire (colored blue) to the terminal marked N
Earth wire (colored green/yellow) to the terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required, they must be readily accessible.

Disposal

EU regulations require refrigeration products to be disposed of by specialist companies who remove or recycle all gasses, metal, and plastic components.
Consult your local waste collection authority regarding the disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.
Alternatively, call the POLAR helpline for details of national disposal companies within the EU.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
POLAR products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR. Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserves the right to change specifications without notice.