VIETA PRO SQ20 Squad True Wireless Earphones User Manual

June 6, 2024
Vieta Pro

Earphones Squad
Ref. SQ20

VIETA PRO SQ20 Squad True Wireless Earphones

Dear Customer, Thank you for purchasing the Squid Bluetooth portable earphones. To ensure proper operation, it is recommended to read this manual carefully before starting using this product.

LetMeRepair
Spain
Do you have problems with your product? Contact us at:
Email: vieta@letmerepair.es
Phone: 952 179 479

USER MANUAL

Bluetooth earphones should be used with compatible devices which support Bluetooth wireless technology. This will allow you to make calls and enjoy music freely at any time.
Please read this user manual carefully before using the headset as your smartphone’s manual regarding the use and activation of the Bluetooth function.
Pay attention to the device safety and maintenance recommendations and for safety reasons, keep the handset out of the reach of children.

VIETA PRO SQ20 Squad True Wireless Earphones -
Earphone

Parameter

  • Model number: Squid
  • Bluetooth version: BT5.0
  • Transmission distance: 15M
  • Charge box capacity: 400mAh
  • Earphone battery: 40mAh
  • Playtime: 3 x 5h = 15h
  • Standby time: >200h
  • Charge time: 1-2h
  • Input: DC 5V
  • Support phone system: Support iOS, Android

Key definition

Power On| When the earphones are removed from the case and they will automatically turn on and sync to each other.
---|---
Power Off| The earphones will power off directly when you put them back into the charging case
Answer Call/End call| One time touch “L” side or “R” side
Refuse the
incoming calls| Long Touch 2S on “L” side or “R” side
Interrupt dial-out calls.| One time touch “L” side or if side
Play/pause| One time touch “R” side
Increase Volume| Long touch “R” side while playing music
Decrease Volume| Long touch “L” side while playing music
Next song| Double Touch “R” side
Previous song| Double Touch “L” side
Wake Up Siri| One time touch “L” side

Charging mode

Charging Earbuds: The red indicator will be on and turned off after charging is finished.
Charging Case: The blue indicator will be flashing and the blue indicator will be on after full charge.
Low battery: Low battery alarm, the prompt low battery when the battery level is lower than 10%. The red light flashes twice in 5 seconds.

Earphone pairing mode

Enter double Earbuds pairing mode.| L/R turns on at the same time when you take them out of the box and they will connect to each other automatically and wait for the Bluetooth to be connected. You can search for references and connect them. This procedure is necessary only the first time you connect to the same device.| The red and blue light flashed.
---|---|---
Enter single Earbud pairing mode.| Only L or R is powered on and Red/Blue light keep flashing| The red and blue light flashed.

REMARK

  1. Bluetooth pairing named “Vieta Pro Squid”
  2. When the music is played, place it into the charging box. At the moment, the Earbuds disconnect from the mobile phone. The Earbuds switch off. When the cover of the charging box is opened again, it powers on automatically for connection.
  3. Connect the mobile phone automatically after power on. If a connection cannot be made automatically, press the POWER key to connect.
  4. If the Earbuds can connect to the mobile phone, reboot and connect again.
  5. Please &ways have a 5V charger.

FCC STATEMENT

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.

Declaration of conformity

Issuer’s name: FRAMASON AUDIO S.A
Address: Av. de Pau Casals 7 Entresuelo 2- 08021 Barcelona (Espalia)
Tel: +34 93 1162491
CIF: A62829841

We declare under our own exclusive responsibility that the product:

  • Description: TWS Earphones
  • Brand: Vieta Pro
  • Model: SQ20
  • Manufacturer: FRAMASON AUDIO S.A
  • Manufacturing country: China referred to in this declaration is in compliance with the essential norms and standards
    EN 62479:2010
    EN 50332-1:2013
    EN 301 489-1 V2.2.0
    EN 301 489-17 V3.2.0
    EN 300 328 V2.1.1
    EN 60950-1:2006+A11:2009+A1:2010+Al2:2011+A2:2013
    in conformity with the provisions of the Directive 2014/53/EU of the European Parliament and of the Council of 29th March 2014.

Barcelona 1 Marzo de 2019

Carlos Alberdi Product Manager

www.vietapro.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals