Shenzhen Kenuo Digital Technology N8+ 4 In 1 Star Projector User Manual
- June 6, 2024
- Shenzhen Kenuo Digital Technology
Table of Contents
Shenzhen Kenuo Digital Technology N8+ 4 In 1 Star Projector
User Manual
- Star Light Projector
- White Noise
- Alarm Clock
- Bluetooth Speaker
| CHARGE FIRST! Before using, plug it into power outlet (adapter
included) until it is fully charged. Then you can start your exciting journey
with it.
---|---
Product Parameter
| Parameter | Description |
|---|---|
| Input voltageand current | 5V1A |
| Operating temperature | -20- 40C ( -4’F- 104’F ) |
| Built-in battery | 3.7V 2200mAh |
| Charging port | Type°C |
| Projection distance | <5 meters ( 16.4ft ) |
| Bluetooth version | 5. 0 |
| Bluetooth distance | <15 meters ( 49.2ft ) |
| Remote control distance | <6 meters ( 19.685ft) |
| Remote control angle | <30″ |
7 Alarm Clock Songs
Number| De s cription| Number| Des c
ription
---|---|---|---
01| Alarm sound 1| 02| Alarm sound 2
03| Classic ringtones 1| 04| Alarmsound 3
05| Classic ringtones2| 06| Piano 1
07| Piano 2| |
14 White Noise Songs
| De s cription | Description | ||
|---|---|---|---|
| S-01 | White noise | S-02 | Bonfire |
| S-03 | Wave | S-04 | River |
| S-05 | Train | S-06 | Dripping water |
| S-07 | Cricket | S-08 | Rain hits the leaves |
| S-09 | Swan lake MusicBox | S-10 | Piano 1 |
| S-11 | Piano 2 | S-12 | Piano 3 |
| S-13 | Piano 4 | S-14 | Piano 5 |
⚠ Attention
- Please connect to the charger before use, please fully charge before use.
- Charging prompt, the indicator light is red when charging, and indicator light is blue after full charged.
- When used as an alarm clock, it is recommended to use it plugged in. This is to prevent the machine from automatically switching off in the middle of the night when you are asleep, or if the low battery alarm disturbs you in the middle of the night.
- Low battery warning, when the built-in battery voltage is low, a “Ding-dong” alarm will sound, and the indicator light below the display screen flashes, the projection lamp and the sound control function are turned off, and the rrelevant button operation will sound an alarm; the indicator light will continue to flash , and the “Ding-dong” will sound every 1 minute Alarm sounds to remind you to charge until the product clock and bluetooth function are turned off at low power; plug in an external power supply, and the alarm will be cancelled.
- The light effect will be better if it is shown in darker places. The projection area is influenced by the distance between the projector and the ceiling.
- For eye protection, please do not look at the projection lamp beads directly.
Package List
4 in 1 star Projector *1
| 120cm charging cable 1| Adapter 1
---|---|---
Manual 1| Remote control 1|
Base *1
Contact Us
Amazon Online Message
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a ci rcuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1 )this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.