Doubleeagle Industry E571-003 Remote Control Car Series User Manual
- June 6, 2024
- Doubleeagle Industry
Table of Contents
USER MANUAL
Main Parameters
Item No. : E571-003
Material: plastic and electronic components
Batteries:
Car battery: 1pc of 3.6V AA rechargeable battery
Remote controller battery:2pcs of 1. 5V AA batteries
Battery Installation
- Open the battery cover of the remote controller as Fig 2A showed, inserts 2pcs of 1. 5V AA batteries, and then screw the cover.
- Open the cover under the truck by screwdriver, inserts 1pc of 3.6V AA rechargeable battery as the correct polarity, and then screw the cover. (Fig 2B) Notice: USB charging time is about 3 to 4 hours.
Basic Operation and Functions
- Forward/backward: To push the Left Trigger ahead/ back, the truck would go forward/backward. (Fig 4B)
- Turn Left/Right: To push the Left Trigger forward/backward, and the Right Trigger turns left/right, the truck would turn left/right. (Fig 4C)
- Excavating: press the key of “Excavating” after starting the car, the car will do a motion. (Fig 4D)
- Unloading: press the key of “Uploading” after starting the car, the excavator will do a motion. (Fig 4D)
- Left/Right Rotation: press the key of “Left(or Right) Rotation”, excavator will do a motion of left (or right) rotation. (Fig 4E) Auto-OFF: after starting the excavator, the car will automatically shut down without receiving any controlling signal in 60 seconds. then all the functions are at a status of standby.
Notice
- Don’t play with the toy on the road, select a safe place for operating to avoid danger.
- Plays the toy in water may cause short circuit damage. Please use a dry cloth to clean the car.
- If abnormal speed or reaction, may be because of insufficient battery power, please charge the battery.
- The batteries should be charged under adult supervision. Please use the batteries recommended.
- Please install the battery in the correct polarity.
- Do not mix new and old batteries together, short-circuited.
- Please charge the battery before initial use.
- Please check the plug case and other units of charger regularly to make sure that it is not broken. Don’t use it again if you find any abnormality in the charger.
- Please do not connect the product to different performance power.
CHOKING HAZARD-small parts, not for children under 3 years.
Specifications colors and contents may vary from illustrations.
Frequency bands: 2405MHz to 2475MHz
Maximum output power: -5.70dBm (for EU)
Manufacturer: Dou beagle Industry (China) Limited.
Address: Xingda Industrial Park, Chenghai District, Shantou City, Guangdong
Province, China.
Importer: JAMARA e.K
Address: in. Manuel Natterer
Am Lauerb0 hl 5 – DE-88317 Aichstetten Germany changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class
B
a digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.