Shenzhen Esorun Technology 20210420 15W Wireless Car Mount User Manual
- June 6, 2024
- Shenzhen Esorun Technology
Table of Contents
Shenzhen Esorun Technology 20210420 15W Wireless Car Mount
Note: For best performance and safety, please read this manual carefully before using the product.
Product Diagram
User Instruction
-
Connect the air vent clamp to the device ;
-
Unscrew nut
-
Place nut around ball head, insert into socket
-
Tighten nut clockwise
-
Attach clamp to car vent
Press the button to unlock the air vent clamp; entry and release to grip the air vent.
-
Connected Power To Charger Use the Type-C cable packed in the box to connect the device and the car charger.
Charging your cellphone
1. After connect this device with your car charger via Type-c cable, press
the spring button on the top right side, will release arm lock, put on your
phone.
2. Press back edge of cradle arm to close arm, lock your phone for charging.
Product Function- Instruction
In the box:
FCC STATMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved
by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
The distance between user and products should be no less than 15 cm