Shenzhen Esorun Technology MAG10000W Magnetic Wireless Power Bank User Manual
- June 6, 2024
- Shenzhen Esorun Technology
Table of Contents
Shenzhen Esorun Technology MAG10000W Magnetic Wireless Power Bank
Warning
When your wireless power bank works improperly
- Make sure there is no any clutters on the wireless power bank.
- When the wireless power bank is over-heating, take your mobile device away from your wireless power bank, and the power bank will stop charging automatically when overheating. Please try charging again when the wireless power bank cooling down.
Remarks
It’s normal that this charger and your smart phone will be hot under operating
conditions, and it may be more hotter when charging and using at the same time
(such as playing music)
In the box
Product Diagram
Wireless Charging Area
Specifications
Capacity: 10000mAh
Micro B Input: 5V/2A, 9V/2A,12V/1.5A
Type-C Input: 5V/3A, 9V/2A, 12V/1.5A
Transmission Distance: ;$6mm
Type-C USB Output: Output:5V 5V/3A, /2.4A,9V 9V/2A, /2.3A,12V 12V/1.5A /1. 7 A
Wireless Output: 15W 5V/4.5A{SCP)
Charging Efficiency: 75%
Product size: 104×71.5×20 mm
How to Use
Use of switches
Press the switch once to turn on the product, the battery indicator will light
up. Then it is in the standby state and other devices can be charged.In the
power on state, and hold the power button for5 seconds to turn off the power.
Tips: In a stand-by state, if you do not perform other operations, it will automatically shut down after about 20 seconds. If you need to use it again, please press the switch again.
Indicator
Wireless Charging
Please fit the product with the back of your iPhone, it will charge your iPhone automatically via the built-in magnetic wireless charging, Max to be lOW.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>