POWERQI LC31 Magnetic Wireless Car Charger User Manual
- June 6, 2024
- POWERQI
Table of Contents
POWERQI LC31 Magnetic Wireless Car Charger
Package contents
Wireless car charger
|
Air vent bracket
---|---
Type-c
charging cable
Installation of charger
① Remove the fixed nut, put the ball in
② Push the ball head into the round hole on the back of the car bracket and
tighten the nut clockwise to adjust the angle of the car wireless charger
③ Fix the air vent mount on the appropriate location of the car air vent clip, and push the fixed lever to fix the wireless charger.
- The f ixed lever has two gear positions. Please select the appropriate gear according to the thickness of the car outlet dip
④ Connect the car wireless charger and car charger by power cable, and insert
the car charger into the car’s cigarette lighter socket.
*car charger wall charger need to buy separately
Charging for mobile phones
⑤ Put the magnetic wireless charging phone one the wireless car charger, they
will align automaticly and starts charging.
Specification
| Product Name | Magnetic Wireless Car Charger |
|---|---|
| Material | ABS+PC , Silicone |
| Size | 90x62x27 mm |
| Weight | 56g |
| Input | SV/3A,9V/2.22A,12V/1.67A |
| Power | SW/7.SW/1 0Vi/1 SW |
| Charging Distance | ~l0mm |
| Conversion | ~68% |
| Frenquency | 110-205KHz |
| Applicable Models | Qi-Compliant Mobile Phones |
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
surrounding the device and 20 cm above the top surface of the device must be
respected.
FCC ID：2AFP2LC31
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>