BATTAT WH1137 Remote Control Dump Truck User Guide
- June 3, 2024
- BATTAT
Table of Contents
BATTAT WH1137 Remote Control Dump Truck
FIRST TIME PLAYING & WAKE UP
- Make sure the ON/OFF switch on the truck and remote are on the ON position (Fig. 1 & Fig. 2).
- Press any button on the truck, as indicated in Fig. 4, then press any button on the remote, as indicated in Fig 3.
- The truck will automatically go into sleep mode after 30 minutes of inactivity to save power. Wake up by pressing any button on the truck Fig. 4 or ipping the power switch from OFF back to ON, as indicated in Fig. 1.
Troubleshooting
- Frequency bands: 2405MHz-2475MHz Maximum radio-frequency power: 5dbm
- Use alkaline batteries for longer play time.
WARNING!: SMALL PARTS – CHOKING HAZARD. Not suitable for children under 3 years
Alignment lever
STEERING ALIGNMENT ADJUSTMENT
If the vehicle does not drive in a straight line, adjust the alignment using the alignment lever. If the vehicle drifts to the left, turn the lever towards the “R”. If the vehicle drifts to the right, turn the lever towards the “L”.
User Guide
-
Do not use near seawater or in dirty and dusty environments.
-
Do not use in the rain or immediately after rainfall.
-
If the truck gets wet, open the battery compartment immediately, remove batteries, and turn the truck upside down to dry.
-
Always clean and dry the truck and remote after using
outdoors to avoid damage. -
Do not overload the truck’s container with more than 700 grams.
-
The remote’s control distance may be reduced when using indoors
WARNING: This toy produces ashes that may trigger epilepsy in sensitised individuals
BATTERY ADVICE
Requires 6 x AA (1.5V) batteries for the truck (included). Requires 2 x AA (1.5V) batteries for the remote control (not included). Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the toy before being charged. Rechargeable batteries are only to be charged under adult supervision. Dierent types of batteries or new and used batteries are not to be mixed. Only batteries of the same or equivalent type as recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed from the toy.The supply terminals are not to be short-circuited.
ATTENTION: When the module’s functions lose performance, follow instructions carefully to install new batteries.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>