POWERQI LC82 2 In 1 Wireless Charger Instruction Manual
- May 15, 2024
- POWERQI
Table of Contents
POWERQI LC82 2 In 1 Wireless Charger
Thanks for choosing us!
This product is a 2 in 1 wireless charger, support phone/Air pods charging at the same time.
Please kindly read the user manual before using and keep it for future reference.
Product Description
Specification
Input: 5V 3A, 9V 3A
Output( 1 ): SW/7.SW
Output( 2 ): SW/7.SW/l0W/lSW
Output(Air pods): SW
Frequency: 115-205KHZ
Charging distance: l0mm
Conversion: ≥ -72%
NW.: 173g
Dimensions: 6517211 mm
Charging Mode
- Make sure the wireless charger dock connect to the power supply.
- Put the smartphone/Air pods properly on the transmitter.
Notes
- Do not squeeze or collisions.
- Do not disassemble or throw into fire or water, to avoid causing a short circuit leakage.
- Do not use wireless charger in severely hot, humid or corrosive environments, to avoid circuit damage and occurs leakage phenomenon.
- Do not place too close with magnetic stripe or chip card ( ID card, bank cards, etc.) to avoid magnetic failure.
- Please keep the distance at least 20cm between implantable medical devices ( pacemakers, implantable cochlear, etc.) and the wireless charger, to avoid potential interference with the medical device.
- To take care of the children, to ensure that they won’t play the wireless charger as a toy, to avoid unnecessary accidents.
The involved images are sketch maps, the final product as per the material subjects.
Includes: wireless charger, Power cable, user’s manual.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the is equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body.
