SIRUI 3T-R Remote Control Tripod Instructions
- June 6, 2024
- SIRUI
Table of Contents
SIRUI 3T-R Remote Control Tripod
Package Includes
Please check carefully whether all the following items are included in the package before using. If any are missing, please contact customer service or your agent
Buttons
USB Receiver
Detachable Remote Control
The vertical notch on the left makes 90° vertical shooting possible. 25° tilt
is available in any direction.
Installation or Removal of the QR Plate
-
Press hard the fixed block and the active plate to the middle until the clamp is released, then take out the QR plate. Let go of your fingers after the QR plate is removed, then the damp will spring back to its original position.
Note: The maximum load for the QR plate is 1000g. Camera gears exceeding this weight may tip forward.
-
Press hard the fixed block and the active plate to the middle until the clamp is released, then install the QR plate. Let go of your fingers after the QR plate is installed, then the clamp will spring back to its original position.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
FCC ID：2AMTD-3T-R
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>