LOCKLY PGI303 Smart Access Control + Video Doorbell Installation Guide
- October 27, 2023
- LOCKLY
Table of Contents
LOCKLY PGI303 Smart Access Control + Video Doorbell
Product Highlights
Section 1 –
- PUSH Lock Control Port
- LOCKLY NC Door Open Detection Port
- BUTTON-SW Door Exit Button Port +
- GND1 Door Exit Button Port –
- BELL-SW Doorbell Button Port +
- BELL Doorbell Signal Port
- GND2 Access Control Power –
- DC12V Access Control Power +
Section 2 – Wiring Diagram
Section 3 – Wired Installation Diagram
Section 4 – Wireless Installation Diagram
Section 5 – Installing the Mounting Plate
- The mounting plate has 3 wire/cable outlets. If you need to use the side outlet (C), remove the hole cover before mounting.
- Position the mounting plate on a flat surface or wall as to where it will be installed. Mark the 4 holes with a pencil. Drill holes with 6mm (diameter) and 30mm depth.
- Insert the plastic wall plugs on the drilled holes.
Section 6 – Installing Ingress Vision Smart Access Control + Video Camera
- Align the Ingress Vision device from the top of the mounting plate then insert till it reaches the bottom of the plate. Ensure the device and video camera are completely tucked.
- 2. Secure the device with a screw at the bottom.
FOR COMMERCIAL USE & PROFESSIONAL INSTALLATION
We’re here to help!prosales@lockly.com
locklypro.com/support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>