KAZE B076DS19WQ Electronic Digital Calliper User Manual

KAZE B076DS19WQ Electronic Digital Calliper

TECHNICAL SPECIFICATIONS

MEASURING RANGE: 0- 1 5OMM/ 0- 6I N, 0-200MM/ 0 -81N
RESOWTION: 0.01 MM/0.00051N
ACCURACY: +0.02MM/ 0.001 IN ( < 100MM)
+0.03MM/ 0.001IN ( > 100-200MM)
REPEATABILITY 0.0lMM/0.0005IN
MAX MEASURING SPEED: 1.5 M/SEC, 60IN/SEC
MEASURING SYSTEM : LINEAR CAPACITIVE MEASURING SYSTEM
DISPLAY: LCD DISPLAY
POWER: ONE ALKALINE LITHIUM BUTTON CELL BATTERY 1.5V, TYPE LR44.
CAPACITY – 180MAH
WORKING TEMPERATURE 5 °C – 40 °C/ 41 TO 104 DEGREE F
NOTE : ACCURACY AFFECTED IN ENVIRONMENTS EXCEEDING 80% RELATIVE HUMIDITY

FEATURES

1. EXTERNAL MEASURING JAWS
2.  INTERNAL MEASURING JAWS
3.  DEPTH BLADE
4. STEP MEASURING FACES
5. BEAM
6. SAE & METRIC SCALE
7. BATTERY COMPARTMENT
8. OUTPUT CONNECTOR
9. LCD DISPLAY
10. SLIDER CLAMP SC REW
11. THUMB-ROLI..ER
12. ON/OFF SWITCH
13. ZERO SWITCH
14. SAE & METRIC CONVERSION SWITCH
    

APPLICATIONS

1. OPERATION:
   SUDER CAN BE REMOVED ONLY AFTER THE LOCKING SCREW ( #10) IS LOOSENED.

2. BASIC MEASURING METHODS:

3. LOOSEN Tl-IE LOCKING SCREW

4. PRESS “ON” BLITTON, SELECT SAE OR METRIC MEASUREMENT BY PRESSING “MM/INCH” BUTTON.
   PRESSING “MM/ INCH” BUTTON AFTER MEASUREMENT WILL DISPLAY THE SAE/METRIC CONVERSION.

5. TO RESET DISPLAY m ZERO, CLOSE EXTERNAL MEASURING JAWS, THEN PRESS”‘ZERO” BUTTON.

• A. OUTSIDE MEMUREMENT
  

• B. INSIDE MEASUREMENT
  

• C. STEP MEASUREMENT
  

• D. DEPTH MEASUREMENT
  

• E. DIFFERENTIAL MEASUREMENT
  

MAINTENANCE INSTRUCTIONS

1. KEEP THE CALLIPER CLEAN AND DRY (LIQUID CAN DAMAGE THE SLIDER)
2. USE A CLEAN, DRY CLOTH TO CLEAN All SURFACES – DO NOT USE SOLVENTS OR SOLVENT BASED CLEANERS.
3. TO SAVE POWER, TURN OFF THE UNIT WHEN NOT IN USE.
4. AVOID CONTACT WITH ELECTRICTY AND/OR ELECTRONIC DEVICES.

BATTERY REPLACEMENT

FLASHING DISPLAY INDICATES LOW BATTERY. TO REPLACE BATTERY, REMOVE BATTERY COVER BY SLIDING COVER IN THE DIRECTION INDICATED AND REPLACE BATTERY WITH POSITIVE SIDE FACING OUT.

TROUBLE SHOOTING

AND REPLACE AFTER 30 SECONDS TO RESET SYSTEM
ACCURACY LESS THAN +/-0.001MM| DIRT IN THE SENSOR| REMOVE SUDER COVER AND ITS ASSEMBLY, CLEAN WITH COMPRESSED AIR 5KG/CM’
NO DISPLAY ON LCD|

1. IMPROPER BATTERY POSITION
2. LOW BATTERY

|

1. REMOVE BATTERY COVER ANO CHECK BATTERY POSITION
2. REPLACE BATTERY

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>