MiBOXER FUT040 Dual White LED Strip Controller Instruction Manual
- June 6, 2024
- MiBOXER
Table of Contents
Dual White LED Strip Controller (433MHz )
Model No.: FUT040
Features
This controller adopts the widely used 433MHz wireless technology with the features of low power consumption, long signal transmitting strong anti- interference, etc. Widely used on the controlling of hotel lighting and home lighting.
| Color temperature adjustable
---|---
| 433MHz RF wireless transmission technology
| Dimmable control
| Remote control
Control distance 30m
Parameters
Remote Control
Working Voltage: 3V(2*AAA Battery)
Working Temp.: -20~60°C
RF: 433MHz
Standby Power: 20uA
Transmitting Power: <10mW
Modulation Method: ASK
Control Distance: 30m
Strip Controller
Input Voltage: DC12V~24V
Output: 12A/Channel
Total Output: Max 12A
Working Temp.: -20~60°C
RF: 433MHz
Control Distance: 30m
Output Connection: Common anode
Products Key Diagram
Connect diagram
Pilot lamp instruction:
Always lighting means working normally; Flash means receiving remote signals.
Note
The factory setting is one remote control one receiver. Users can group it as
per the need. One remote can control countless receivers, but one receiver
just can be controlled by a max of 4 remotes.
Linking the controller
Switch off the light, after 10 seconds switch on again.
When the light is on, short press “ ” 1 time within 3 seconds.
The light blinking 3 times slowly means the linking is done successfully.
**** If the light does not blink slowly, the linking failed, Pls switch off the light again, and follow the above steps again.
Unlinking the controller
Switch off the light, after 10 seconds switch on again.
When the light is on, short press ” ” 5 times within 3 seconds.
The light blinking 6 times quickly, means unlinking successfully.
If the light does not blink quickly, the unlink failed, pls switch off the
light again, and follow the above steps to unlink again.
Attention
- Please check whether the input voltage of the constant voltage power supply is in accordance with the controller, and please check the connection of both the cathode and anode, otherwise, the controller will be damaged.
- Please don’t connect wires with power on. Please turn it on again only when it is in the right connection and has no short circuit.
- Non-professional users cannot dismantle the controller directly, otherwise, it may damage the controller.
- Please do not use the controller in a place with a wide range of metal areas or strong electromagnetic waves nearby, otherwise, the remote distance will be seriously affected.
Made in China
Documents / Resources
|
MiBOXER FUT040 Dual White LED Strip
Controller
[pdf] Instruction Manual
FUT040, Dual White LED Strip Controller
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>