MiBOXER 2.4G 2 In 1 LED Controller Instruction Manual
- May 15, 2024
- MiBOXER
Table of Contents
MiBOXER 2.4G 2 In 1 LED Controller Instruction Manual
Product features
Product adopt the widely used 2.4GHz wireless technology with the features of low power consumption, long signal transman and strong an-interference, etc. Product has auto-transman fanon. Widely used on the controlling of hotel lining and home lining.
Set up output mode
Set up correct output mode based on the feature of lights Seng method: Press “SET” button canorously to switch output mode (aenon: it will log out without operaon within 3 seconds)
Output mode sheet ( confirm output mode based on color of indicator)
PUSH Dimming
Short press PUSH switch: Turn ON/OFF light
Long press PUSH switch:
- Stepless dimming brightness.
- Long press and release your finger, then repeat long pressing to increase or decrease brightness.
Compatible with these 2.4G RF remote controls (Purchased separately)
2.4G RF Remote control instruction
1). Linking Code Instructions
⚠ Linking failed if light is not blinking slowly, Please follow above steps again. (Note: Light that have linked can’t link again)
2). Unlinking Code Instructions
⚠ Unlinking failed if light is not blinking quickly, Please follow above steps again. (Note: Light haven’t linked that don’t need to unlink)
3). Auto transmitting (2.4G RF remote signal)
The light can transmit remote signal to another light atomically while the
distance between lights are 30m, the remote control distance is unlimited.
(Aenon: all lights must be linked with same remote)
Auto transman
4). PWM high frequency / low frequency switching (only for remote
control)
Switch to high frequency: Press “OFF” button 1 me within three seconds and
press “ON” button 5 mes, Caveated successfully once led light flashes 2 mes
quickly.
Switch to low frequency: Press “ON” button 1 me within three seconds and press
“OFF” button 5 mes, Activated successfully once led light flashes 2 mes
slowly.
5). “Do Not Disturb” mode is caveated and shut down (default activated)
Turn on “Do Not Disturb” mode (wide using in the area which have power failure
frequently to save energy)
2.4G RF Remote turn on and turn off instrucon Turn on “Do Not Disturb” mode:
Press “OFF” buon three mes within three seconds and press “ON” buon three mes,
Acvated successfully once led light flashes four mes quickly.
Aenon: Do not disturb mode is acvated 1. When the light is OFF status (For
example: Use app or remote to turn off light)
The light is OFF status once you turn off power and turn on again. (User must
turn off and turn on power twice mes to acvate light or use APP / remote to
acvate light) 2. When the light is ON status The light is ON status once you
turn off and turn on power one me.
Turn off “Do Not Disturb” mode: Press “ON” button three mes within three
seconds and press “OFF” button three mes, closed successfully once led light
flashes four mes slowly. Attention: The light will be always “ON” status if
you turn on and turn off power once user closed “Do Not Disturb” mode.
Attention
- Please turn off power supply before installing.
- Please ensure input voltage to be same as requirements from device.
- Don’t disassemble device if you are not expert, otherwise it will damage it.
- Please do not use the light in the place with widely range metal area or strong electromagnet wave nearby, otherwise, the remote distance will be seriously affected.
https://miboxer.com/light/video/1pc_remote.html
Scan QR code to watch 2.4GHz series video instruction Or enter into following link directly
https://miboxer.com/light/video/1pc_remote.html
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>