rfsolutions RIOT-SENW-PIR-8T1 Remote Control Fob User Guide
- June 6, 2024
- rfsolutions
Table of Contents
rfsolutions RIOT-SENW-PIR-8T1 Remote Control Fob
Operation
- Open Enclosure
- Turn Power ON
- Learn Sensor to RIoT-Hub
- Learn Sensor to your Smartphone/device
- Deploy
Switch
Note: The Switch/LED will
operate at any time, but Power Must be ON for the sensor to Transmit
Tip: Mount the sensor ideally >1metre above ground level.
Hereby, RF Solutions Limited declares that the radio equipment type defined
within this document is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at
the following internet address:
www.rfsolutions.co.uk
RF Solutions Ltd. Recycling Notice Waste Batteries and Accumulators Directive 2006/66/EC Meets the following EC Directives:
DO NOT Discard with normal waste, please recycle.
ROHS Directive 2011/65/EU and amendment 2015/863/EU Specifies certain limits
for hazardous substances.
Where batteries are fitted, before recycling the product, the batteries must
be removed and disposed of at a licensed collection point. RF Solutions
battery producer number: BPRN00060.
WEEE Directive 2012/19/EU
Waste electrical & electronic equipment. This product must be disposed of
through a licensed WEEE collection point. RF Solutions Ltd., fulfils its WEEE
obligations by membership of an approved compliance scheme. Environment agency
number: WEE/JB0104WV.
Disclaimer
Whilst the information in this document is believed to be correct at the time
of issue, RF Solutions Ltd does not accept any liability whatsoever for its
accuracy, adequacy
or completeness. No express or implied warranty or representation is given
relating to the information contained in this document. RF Solutions Ltd
reserves the right to make changes and improvements to the product(s)
described herein without notice. Buyers and other users should determine for
themselves the suitability of any such information or products for their own
particular requirements or specification(s). RF Solutions Ltd shall not be
liable for any loss or damage caused as a result of user’s
own determination of how to deploy or use RF Solutions Ltd’s products. Use of
RF Solutions Ltd products or components in life support and/or safety
applications is not authorised except with express written approval. No
licences are created, implicitly or otherwise, under any of RF Solutions Ltd’s
intellectual property rights. Liability for loss or damage resulting or caused
by reliance on the information contained herein or from the use of the product
(including liability resulting from negligence or where RF Solutions Ltd was
aware of the possibility of such loss or damage arising) is excluded. This
will not operate to limit or restrict RF Solutions Ltd’s liability for death
or personal injury resulting from its negligence.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>