ZALMAN Z1 ATX Mid Tower PC Case User Manual
- June 6, 2024
- ZALMAN
Table of Contents
ZALMAN Z1 ATX Mid Tower PC Case
Cautionary Note
- Please read this manual thoroughly prior to installation.
- Before installing, check the components and condition of the product, and if any problem is found, contact the retailer.
- Please wear gloves while handling this product to prevent injuries.
- Incorrect cable connections may cause short circuits leading to fire hazards.
- Do not block the front intake vent or the rear exhaust vent.
- Keep this unit away from heat sources, direct sunlight, water, oil and place the unit on a flat and well- ventilated area.
- Do not clean the product surface with chemicals or wet cloth. (chemicals: industrial alcohol, pait thinner and organic solvent etc.)
- Avoid inserting objects or hands into the system while it is in operation to prevent product damage and injuries.
- Zalman Tech Co., Ltd. is not responsible for any improper use.
- Product design and specifications may be revised to improve quality and performance.
Components
A Bolt
(#6-32*5mm) x 13
[PSU,PCI]
|
B Bolt
(M3*5mm) x 25
[M/B,FDD,SSD,ODD]
|
C Bolt
(M3*5mm) x 4
|
Stand
Off x 6
---|---|---|---
Cable
Tie x 5
|
HDD
Guide
|
Manual
x 1
Front I/O Ports
| Part| #|
Part
---|---|---|---
①
| Power Button| ②| Reset Button
③| USB 2.0| ④|
USB 3.0
⑤
| Headphones| ⑥| Mic
⑦|
HDD LED
Installation
-
Side Panel Removal
-
Motherboard Installation
– There are 6 Stand-offs preinstalled. Please refer to the diagrams below for additional Stand Off positions (based on motherboard type).
-
VGA Card Installation
① Unfasten the Hand Screw holding the PCI Cover and disassemble the cover.
② Remove the PCI Slot Cover.
③ Install the VGA Card and fasten with a fixing screw.
-
5.25″ and 3.5″ Drive Installation
4-1) ODD Installation
※ ODD Bracket removal
4-2) 3.5 Installation
1) Front Cover Removal
2) 3.5 Installation
-
3.5″ HDD Installation
– Use the HDD Guide to install 3.5″ HDD.
※ When transporting an assembled system, please secure the HDD with Bolt C as
shown above.
-
Cable Connection
-
2.5″ HDD and SSD Optional
– 2.5″ HDD and SSDs can be installed on the right side of case as shown in the diagram below.
Documents / Resources
|
ZALMAN Z1 ATX Mid Tower PC
Case
[pdf] User Manual
Z1, ATX Mid Tower PC Case
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>