GRYPHON SGT110 Remote Ordering Options Instruction Manual
- May 15, 2024
- GRYPHON
Table of Contents
GRYPHON SGT110 Remote Ordering Options
Product Usage Instructions
Remote Programming Steps
- Depending on your motor’s model, you may need to remove a screw to allow the hinged cover to open. Locate the RED push button on the main circuit board.
- Press the RED button for approximately 3-5 seconds until the LED indicator light starts flashing, indicating the motor is in ‘learn mode’.
- On the new remote, press and hold any button for 1-2 seconds to program it to operate the door. The motor’s LED should stop flashing once the remote is programmed.
Deleting All Remotes from Receiver
- To erase all remotes from the motor’s memory, push and hold the RED button on the circuit board panel for 10 seconds.
- After 3 seconds, the light will start flashing, and after 10 seconds, it will remain on.
- Release the RED button after the light remains on and check to ensure all remotes have been erased.
Receiver Compatibility
- Compatible with Gryphon TM50, TM60, TM70, TM80 Receivers.
- While every effort has been made to ensure accuracy, we assume no liability for errors or omissions.
- Information in this document is subject to change without prior notice.
FAQ
- Q: How do I know if the remote programming was successful?
- A: The LED indicator light on the motor should stop flashing once the remote has been successfully programmed.
- Q: What should I do if my motor does not enter ‘learn mode’?
- A: Check the battery of the remote and ensure proper positioning while pressing the RED button on the motor’s circuit board.
REMOTE ORDERING OPTIONS
SPECIFICATIONS
- SGT Frequency: 433Mhz
- Buttons: 4
- Battery: LR27A
Remote Programming Steps
Program Existing Remote to New Remote
- Depending on your motor’s model you may need to remove a screw to allow the hinged cover to open. Once open locate the RED push button which is located on the main circuit board.
- Press the RED button for approximately 3-5 seconds until the LED indicator light begins to flash. Once flashing this indicates that your motor has successfully entered ‘learn mode’.
- On the new remote, press and hold any button (should only take about 1-2 seconds) that you wish to operate the door. The LED on the motor should stop flashing once the remote has been programmed.
Deleting All Remotes from Receiver
- To erase all remotes from the motor’s memory, push & hold the RED button on the circuit board panel for 10 seconds.
- After three seconds the light will begin to flash & after 10 seconds the light will remain on.
- After the light remains on, release the RED button & check to ensure your remotes have been erased.
COMPATIBLE WITH
RECEIVER COMPATIBILITY
- Suits Models: Gryphon TM50,TM60,TM70,TM80 Receivers
Whilst every effort has been made to ensure the accuracy of the information supplied herein, we assume no liability for any errors or omissions. Information contained in this document is subject to change without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>