AUDIOropa RM581000 Speech transfer system Instruction Manual
- June 6, 2024
- AUDIOropa
Table of Contents
AUDIOropa RM581000 Speech transfer system
Above view
- Status indicator. This lights up red when the unit is ready for operation.
- Microphone socket: Insert the microphone neck and tighten the knurled screw to fix it in place.
- Loudspeaker: Outputs the transmission of the external communication unit
- Without relevant function.
- Intercom button: Press the button to start voice transmission via the external communication unit. Press the button again to end the transmission. During an active transmission, the LED above the intercom button lights up blue.
- Without relevant function.
- Level switch. There are 3 level settings available:
Switch to front: Loud
Middle position : Standard
Switch to rear: Soft The standard setting is used by default.
Side view
Connection cable
- Power supply: For connection with the power supply unit.
- RJ45-connector: Without relevant function.
- Audio output: For connection to loop amplifiers, e.g. AUDIOropa LA-70 or other independent audio systems. Use the included connector block for this purpose.
- Connector for the external communication unit.
External communication unit
- Communication unit: Serves as loudspeaker and microphone for speech transmission to the microphone base.
- Connector to the microphone base.
Connection diagram
Dimensions, in mm
Installation instructions
- Place the microphone base in a suitable location.
- Attach the external communication unit to a glass pane or other smooth and clean surface. To do this, peel off the protective paper from the adhesive surface and stick the communication unit in the desired location.
- Lay the cable using the cable holders and cable ties. Stick the self-adhesive cable fixings in the desired place and fasten the cable to the cable holders with the cable ties.
- If necessary, the strain relief can be placed over the cable and fixed with the included double-sided adhesive tape strip.
Specifications
- Power supply:DC 12 V / 1,5 A
- Power consumption:≤ 5 W
- Connectors: Power supply, analog audio output, network connector (without function), PS/2 connector for the external communication unit
- Signal-to-noise ratio:90dB
- Frequency response:20 Hz – 16 KHz
- Audio sampling:8 KHz – 32 KHz
- Temperature range:-10°C – 55°C
- Humidity range:≤ 90% RH (non-condensing)
- Dimensions / weight:Microphone base 95 x 160 x 46.5 mm / 0.44 kg External unit 83 x 102 x 24 mm / 0.2 kg
This device complies with the following EC directives:
- – 2011 / 65 / EC + 2015 / 863 / EC RoHS-directive
- – 2012 / 19 / EC WEEE-directive
- – 2014 / 30 / EC EMC-directive
- – 2014 / 35 / EC LVD-directive
Compliance with the directives listed above is confirmed by the CE seal on the
device. CE compliance declarations are available on the Internet at
www.audioropa.com.
Technical specifications are subject to change without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>