DOMUS LINE RC1 Receiver Controller TWF Instruction Manual
- June 6, 2024
- DOMUS LINE
Table of Contents
DOMUS LINE RC1 Receiver Controller TWF Instruction
INSTALLATION MANUAL
DOMUS LINE Srl
Via Maestri del Lavoro, 1 33080 PORCIA PN Italy
phone
0039 0434 595911
fax
0039 0434 923345
e-mail website
info@domusline.com
www.domusline.com
Protection class III device. Power must be supplied by a safe power supply.
The product must be disposed of separately from urban waste, delivering it to
the collection centres established by the prevailing standard. The adequate
sorted waste collection contributes to preventing negative effects on the
environment and health and favours reuse and/or recycling materials. Incorrect
disposal of the product implies the application of the administrative
sanctions envisaged by the prevailing regulation.
Device only for indoor installation. Leuchte nur für die Installation im
Innenbereich. L’appareil doit être uniquement . Aparato para un solo uso en un
ambiente interior. Apparecchio per sola installazione in ambiente interno.
INSTALLATION MANUAL
TECHNICAL DATA:
FOR RECEIVER CONTROLLER TWF: Power supply: 24Vdc Max power: 60Watt
FOR REMOTE CONTROL TW : Remote control range 15 meters. The battery type used:
CR2032 (3V) lithium.
WARNINGS
Safety is guaranteed if these instructions are followed and therefore they
must be kept. Installation may require qualified personnel to be involved.
Before proceeding with the installation of the device ensure that the
environmental conditions are in compliance with and suitable for the product
characteristics. Before any operation on the device remove mains power.
INSTALLATION:
- Fix the support bracket (8) (fig.1) using the screws (9) supplied or a double-sided tape (7).
- Insert the battery in the remote control (10) as shown in fig.2.
PROGRAMMING THE RECEIVER Fig.4
(maximum 7 transmitters with one receiver):
- Connect the receiver to the converter (not supplied in the package) as shown in fig.4.
- Connect the luminaires.
CAUTION : do not connect any luminaire directly to the connector of the receiver, but always use the voltage distributor 11 supplied in the package.
- Connect the power plug to the power supply, the blue LED (2) flashes.
- Briefly press the button (2) on the receiver.
- The blue LED (2) will remain lit for 60 sec. by which the programming operation must be completed, holding down for more than 5 sec. the power button (3) on the transmitter (1). The blue LED (2) turns off confirming the correct programming of the system.
- It is possible to control multiple receivers with a single transmitter, programming them as indicated in fig.5
OPERATION (fig. 6):
- Key 3 = ON/OFF
- Key 4 = Increase the brightness
- Key 5 = Decrease the brightness
- Switch 6 = Light colour temperature adjustment
RECEIVER PROGRAMMING RESET (fig.7):
It is possible to cancel the programming of the transmitters paired with the
receiver proceeding as follows:
– Press button (2) briefly, the blue LED flashes once.
– Press button (2) in quick succession three times; the LED flashes twice; at
this point the receiver is completely reset.
WARNING:
After 60 sec. of inactivity, the control system goes in “STAND-BY” mode,
during which it is not possible to make any adjustments until one of the
buttons on the transmitter (1) is pressed.
BATTERY-POWERED DEVICES:
Dispose of batteries according to local regulations. Some batteries can be
recycled and it can be possible to dispose of them at the local recycling
center. If it is not possible to find the applicable regulations in your area,
check the instructions of the battery manufacturer.
IMPORTANT:
The installation must be performed by qualified personnel following the
instructions attached and those in fig.3
WARRANTY
The warranty on the device is valid only if powered by a power supply provided
by DOMUS Line. The warranty general terms and conditions for this device are
available at www.domusline.com
INSTALLATION MANUAL
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.）
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC warning
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device. The
device has been evaluated to meet general RF exposure requirements. The device
can be used in portable exposure condition without restriction.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>