baby trend Sit N Stand 2.0 Stroller Instruction Manual

: June 4, 2024
: baby trend

Table of Contents

baby trend Sit N Stand 2.0 Stroller
WARRANTY
WARNING
PARTS PIEZAS
ASSEMBLY ENSAMBLAR
SAFETY SEGURIDAD
MAINTENANCE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

baby trend Sit N Stand 2.0 Stroller

WARRANTY

DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR REPLACEMENT PARTS, SERVICE AND REPAIR.
The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product which has been subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration or accident, or has had its serial number altered or removed invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user. Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/limited-warranty for complete warranty details.

WARNING

WARNING:
Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference.
WARNING:
Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out, always use the safety harness and insure that the children are properly positioned according to these instructions.
WARNING:
Never leave children unattended.

Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause a hazardous, unstable condition.
Be certain the stroller is completely opened and locked in place before allowing a child near the stroller.
NEVER use the stroller on stairways or escalators.
NEVER allow your stroller to be used as a toy.
To clean use only mild household soap or detergent and warm water on a sponge or clean cloth.
Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed.
Discontinue use of stroller should it malfunction or become damaged. Please contact our customer service department to arrange for repair or obtain replacement parts.
NEVER run or jog with this stroller.
The maximum weight that can be carried in the storage basket is 10 lb (4.53 kg). Mobile phone positioning parent tray and child tray each hold 5 lb (2.26 kg). Excessive weight may cause a hazardous unstable condition to exist.
he maximum weight for the front seat is 50 lb (22.68 kg). The maximum weight for the platform / jumpseat is 50 lb (22.68 kg).
The rear stand on platform / jump seat is designed for a child who is at least 2 1/2 years old and is not over 40 inches (101.6 cm) tall. The maximum weight for the following combined features still within the individual limits is 110 lb (45.35 kg): front seat, platform / jumpseat , and any of the accessories. Excessive weight may cause a hazardous unstable condition to exist.

PARTS PIEZAS

Check that you have all the parts for this model before assembling the stroller. Verifique que tenga todas las piezas para este modelo antes de montar el carrito.

IMPORTANT!
To ensure the safe operation of your stroller, please follow these instructions carefully. Please keep these instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. NEVER use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.

ASSEMBLY ENSAMBLAR

Lay the frame on the side opposing the fold latch. Release the fold latch by pulling it outward (Fig. 1a). Slightly open frame to remove the canopy from the frame
(Fig 1b).
Put the frame upright and firmly pull backward on the stroller handle to snap the frame open (Fig. 1c).
NOTE: The frame must fully click into position.
Insert each front wheel into the housing on both sides of stroller frame. Line up the peg with the housing and firmly push into place (Fig. 2).
From the underside, align the rear axle with platform over the rear frame tubes. Push in evenly on both sides until secure (Fig. 3a).

Ensure to press the rear axle-platform under the lower bar (Fig. 3b). NOTE: Ensure the rear axle-platform clicks into position on both sides. Pull on each side to ensure it is locked in place before use.NEVER use stroller if the rear axle-platform does not lock into place. If you need assistance, please contact the customer service line for additional assistance: 1(800) 328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST).

To attach child tray: Push tray downward and onto each side of the front armrests until both sides snap into place (Fig. 4a). Check that the tray is secured by slightly pulling it upwards.
To access child seat: pull one release lever (Fig. 4b) on the underside of the child tray and lift upward. Either side can rotate up to access the seat (Fig. 4c). NOTE: To remove the child tray: Press the 2 buttons to rotate tray up. Pull each release lever on both sides of the tray and pull upward.
to attach the canopy: align both sides of the canopy clips onto the plastic tabs. Slide clips forward to lock into place (Fig. 5a). NOTE: Ensure the canopy is completely snapped into position.To open the canopy: push front bar forward while holding back of canopy. Canopy rachets forward or backward (Fig. 5b)
To close the canopy: pull front of canopy back towards stroller handle (Fig. 5c).
To remove the canopy: Slide both canopy clips back towards the stroller handle (Fig. 5a).
To access front of basket: open and close the leg rest with the hook and loop fastener. Lift the leg rest to access the basket (Fig. 6a).
• To access rear of basket: Locate the convenience basket below the rear jump seat (Fig. 6b). Ensure the hook and loop straps are attached to the lower frame joint (Fig. 6c).
WARNING:
Do not place hot liquids or more than 5 lbs (2.26 kg) in the parent tray. Serious burns or unstable conditions can result.
WARNING:
Care must be taken when folding stroller to prevent damage. Make sure all accessories, mobile phones, diaper bags or purses are removed before folding. Failure to remove items in, or on the stroller may result in damage to the stroller or the item (s) if not removed. Baby Trend® will not be liable or warrant any damage.
To Insert The Parent Tray: (1) Face the tray with the prominent arch side towards
Align the parent tray tabs to the inner tabs on both sides of the stroller. Press the tray down firmly until both tabs click into position (Fig. 7b). Colocación de la bandeja para padres
Mobile phone positioner: Align mobile phone to the clip and insert it through the grips. Make sure to push the phone all the way down into the positioner The positioner may not accommodate all mobile phones or other devices. Do not use positioner as a secure holder when stroller is not in use or if your phone is loose or is too large. Removal: Under the stroller frame locate the parent tray tabs. Press them inwards and lift up the tray from the housing

WARNING:
Always set brakes when the stroller is not being pushed so that the stroller will not roll away. NEVER leave stroller unattended on a hill or incline as the stroller may slide down the hill.

To engage rear brakes, apply downward pressure to the brake levers located on the rear axle (Fig 8a). The stroller may require forward or rearward movement in order to engage the brake. Check that the stroller will not move once the brakes are properly applied. To release, gently lift up on the brake levers (Fig. 8b).
WARNING:
Avoid serious injury from falling or The shoulder straps of the 5- point harness have multiple positions. Select the position that places the shoulder strap level with, or below the top of the child’s shoulderTo secure the child, place the safety harness around the child’s waist and over the shoulders. Place the crotch strap between the child’s legs. Insert the male end of each shoulder/waist belt into the crotch buckle. Tighten all buckles to the proper fit for the child o make adjustments: Push the button on the center clasp and all the harness straps will release. Pass them through the slots on the seat.

SAFETY SEGURIDAD

Use the hook and loop fasteners on the rear seat opening to access straps and rethread. Select the position that places the shoulder strap level with, or below the top of the child’s shoulder
Have the child sit on the jump seat facing backwards. Secure the child with the jump seat 3-point harness(Fig. 10a). Put the seat belt around the child’s waist, and buckle to the crotch strap (Fig. 10b). Adjust the seat belt to be snug around the child’s waist.

To attach the infant car seat in the front seating position: Attach the child tray and rotate to the vertical position Position the infant car seat facing toward the rear of the stroller and latch it into the tray. Take the short clip out of the pocket

Remove the short clip for the infant car seat To remove the Infant Car Seat, squeeze the release handle located at the Top-rear or Foot-end of the seat and carefully lift upward on the seat. Place the short clip into pocket press the pin located behind the wheel hub. Pull the wheel out from the hub (Fig. 17).
Release the side panels from the 2 tabs. Remove the seat fabric from the backrest framing • Replace with split strap anchor. Insert through Slot (1), from underneath the inner armrest tug to ensure its anchored and pass through Slot (2). Complete attachment and tug to ensure it anchored correctly (3) (Fig. 19e).

MAINTENANCE

SEAT PAD
To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.

OTHER
Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed. The Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST).