SC T HS04-4K6G 4K 60Hz 4×1 HDMI Switcher User Manual

: June 6, 2024
: SC T

SC T HS04-4K6G 4K 60Hz 4×1 HDMI Switcher

Introduction

HS04-4K6G is a 4 input HDMI automatic switcher that supports superior resolution up to 4K@60Hz 4:4:4. Besides, the auto-scan function allows the switcher to switch to an available or last connected HDMI source automatically.
It is a perfect solution for home theaters, security rooms, and so on –no more hassles plug-ins for multiple HDMI devices.

Features

Resolution up to 4K@60hz 4:4:4.
Built in RS232 console port for remote control or firmware update.
Supports auto-scan function, automatically switch to the next available input when the selected one is unable to display.
Supports auto switching function, automatically switch to the last connected input source.
Managed via front panel buttons, IR remote, RS232.

Panel View

HS04-4K6G

IR Remote Control Setting

This device could use IR remote control for function setting and control, The ID number must be setup before using IR remote control or change new batteries.
Setup IR remote ID number
Press and hold “Power Symbol” button and press number 0.

Installation View

HS04-4K6G

LED Indication

Panel Button Function

Remote Control Operating A, B Mode Switching

There are two remote control operating modes: When this device power on, you could switch A, B mode by pressing the panel “power” button and remote control “*” button together.

Mode A operating mode: It come with auto scan & auto jump functions. Mode B operating mode: When auto scan & auto jump functions no need to use, which only need single button for quick operation on AV switch.

Factory default is set to (Mode A).

IR remote control Mode A Operating

IR remote control Mode B Operating

Auto Scan Function

Under auto scan operation, if the selected input video signal disappears over 0.5 second, it would automatically select the previous or next input with video signal.

Auto Jump Function

Under auto jump operation, if there is a new video signal input, it will automatically switch to a new video signal input.

LED brightness setting

LED brightness could be set up as the following 4 levels

Minimum Brightness
Normal Brightness
Maximum Brightness
Brightness auto change

Factory default is set to level 3.

Under Brightness auto change mode, press any button or IR remote control, or video signal changed (video signal disappears or show up), LED status will show the maximum brightness up to 5 seconds then back to the minimum brightness.

Computer Remote Control Function

This RS-232 terminal could be connected with computer, to use terminal program for remote control operation, the communication format is 9600, 8, N, 1 (9600 Bps, 1 start bits, 8 data bits, 1 stop bit).

Under remote control operation, If it shows COMMAND, then it is “under command mode”. It could easily be operated and set by entering the following commands in the chart.

Press Enter: if it shows OK! then the previous command is completed; showing ERROR! indicates the previous command is incorrect.

Command Mode Instruction

Space characters between the command and parameters can be ignored.

Virtual Remote Control Mode

Showing 「KEYPAD :」 when it is under virtual remote control mode, which you could enter the following commands at the terminal to simulate the IR remote control operation.
After press command if it shows 「OK!」 then the previous command is executed; showing「ERROR!」 indicates the previous command is incorrect.

System Activate Virtual Remote Control Mode A/B Operate description

MODE A：
MODE B：

System Standby Virtual Remote Control Mode A/B Operate description

MODE A：
MODE B：

Remark

There are some DVD equipment still have +5V signal output under power off status, it will cause auto jump and auto scan function abnormal, please disable auto jump and auto scan function to avoid any abnormal operation.