PARKSIDE Battery Operated LED Work Light Instruction Manual

PARKSIDE Battery Operated LED Work Light

Introduction

Congratulations!

With this, you have chosen a high-quality product. The operating instructions are an integral part of this product. They contain important information for safety, use and disposal. Familiarise yourself with all of the operating and safety information before us-ing the product. Only use the product as described and for the specific areas of application. Provide all of the documentation when passing the product on to third parties. Keep the instructions for future ref-erence.

Explanation of symbols

The following symbols and signal words are used in these operating instructions, on the product or on the packaging.
In the following, the Battery-Operated LED Work Light is referred to as the product.

WARNING!

This signal symbol/word indicates a hazard with a high level of risk which, if not avoided, may result in death or serious injury.

CAUTION!

This signal symbol/word indicates a hazard with a low level of risk which, if not avoided, may result in minor or moderate injury.

NOTE!

This signal word warns of possible property damage or provides you with useful additional information re-garding the use.

• This symbol indicates interior use only.
• This symbol indicates usage.
• This symbol indicates potential danger to children.
• This symbol indicates the age rating of the product.
• This symbol indicates a risk of glaring. This symbol indicates the ON/OFF switch.
• This symbol indicates potential danger in relation to electric shocks.
• This symbol indicates potential danger in relation to overheating.
• This symbol indicates potential danger in relation to explosions.
• This symbol indicates potential danger from handling batteries / rechargeable batteries.
• This symbol indicates that batteries are in-cluded in the scope of delivery.
• This symbol indicates direct current.
• This symbol indicates the electrical power: watts.
• This symbol provides information regarding the illuminance.
• This symbol indicates Protection Class IP20. (No protection against water, but against solid objects of more than 12.5 mm diameter. The product may only be used in a dry environment.)
• This symbol indicates protection class III. SELV: safe extra-low voltage
• These symbols inform you about the disposal of the packaging and product.
• Conformity declaration (see Chapter „8. Conformity declaration”): Products that are marked with this symbol fulfil all appli-cable Community regulations of the European Eco-nomic Area.
• This symbol indicates the importer.

Safety Intended use

• This product is not suitable for household room lighting.
• WARNING! The product may not be used near liquids or in damp spaces. There is a risk of injury from electric shock!
• The product is not intended for commercial use. Different use or a modification to the product are not deemed as intended use and may lead to risks, such as injuries and damage. The distributor assumes no liability for damage that results from improper use.
• The product is exclusively suitable for interi-or use.

The lamp is intended for normal use and is not suit-able for harsh operating conditions.

3. Scope of delivery (Fig. A)

1 x Battery-Operated LED Work Light 1
4 x batteries, type AA
1 x Operating instructions

4. Technical specifications

Type: Battery-Operated LED Work Light
b 367072_2101
Tradix Item No.: 367072-21-A
Operating voltage : 2 x 3 V
Total output: 10 W

• – Light bulb: 2 x 5 W COB LED
  • (white, not replaceable)
  • Illumination time: approx. 2h (both spotlights) / approx. 4h (one spotlight) according to ANSI standard
• max. 700 lm
• Protection class: III/
• Protection type: IP20 – Dimensions when folded up: approx.
  • 20 x 14 x 5.5 cm (W x H x D) Total dimensions unfolded:
  • 20 x 23.3 x 5 cm (W x H x D) Production date: 06/2021 Warranty: 3 Years

Safety information

• If children play with the product or the packaging, they may injure themselves or suffocate!
• Do not let children play with the product or the packaging.
• Supervise children who are close to the product.
• Keep the product and the packaging out of reach of children.
• Children from the age of 8, as well as people with impaired physical, sensory or 8 mental capabilities or with a lack of expe-rience and knowledge, must be supervised 8 mental capabilities or with a lack of expe-rience and knowledge, must be supervised
• Children are not allowed to play with the product.
• Maintenance and/or cleaning of the product is not allowed to be performed by children without supervision. Observe national regulations!
• Observe the applicable national requirements and regulations for the use and disposal of the product.
• The product is not allowed to be used in an explosive (Ex) environment. The product is not approved for an environment, in which flammable liquids, gases or dust are present
• Do not look directly into the lamp and do not direct the lamp into other people’s eyes. This can impaired the eyesight
• Do not use the product in the case of malfunctions, damage or defects. If you determine a defect on the product, remove the batteries from the device and have the product inspected and repaired, if necessary, before putting it into operation again.
• The LEDs are not replaceable. If the LEDs are defective, the product must be disposed of.
• Significant danger can occur for the user in the case of improper repairs
• The casing must not be opened and the product must not be manipulated/modified under any circumstances. Manipulations/modifications can cause danger to life from electric shock. Manipulations/ modifications are prohibited for approval reasons (CE).
• The product must not be covered up during use.

Safety instructions regarding batteries

• Batteries may be fatal if swallowed, sothis article and its batteries must be stored out of the reach of small children.
• Swallowing can lead to chemical burns, soft tissue perforations and death. Serious internal chemical burns can already occur within 2 hours of ingestion.
• If a battery has been swallowed, please consult a doctor without delay!
• Keep the batteries out of the reach of children

warning

• Never recharge nonrechargeable
• batteries, do not shortcircuit and/or open them. This may result in overheating, risk of fire or bursting.
• Keep the product away from heat sources and direct sunlight, the batteries may explode if overheated. There is a risk of injury
• Leaked or damaged batteries may cause chemical burns if they come into contact with skin. Do not touch leaked batteries with bare hands; therefore ensure that you wear appropriate protective gloves in this case!
• Only use type AA batteries from the same manufacturer.
• Insert the batteries into the designated battery compartment with the correct polarity.
• Do not use combinations of old and new batteries or rechargeable batteries.
• Store batteries in a dry and cool, not damp, place.
• Never throw batteries into fire.
• Do not shortcircuitbatteries.
• Disposable batteries also lose part of their energy during storage.
• Remove the batteries if the device is not in use.
• Discharged batteries must be immediately removed in order to avoid battery leakage and thus damage to the device.
• Empty batteries or used rechargeable batters must be disposed of properly.
• Store disposable batteries separately from discharged batteries, in order to avoid mixups

CAUTION!

Start-up

1. Remove all packaging materials.

2. Check whether all parts are available and undamaged.
   If this is not the case, notify the specified service address.
   The batteries 2 are already inserted in a delivered state. The batteries 2 are protected against discharge by a protection wafer 3 , which must be removed before first use

3. Unfold the product 1 .

4. Unlock the battery compartment cover 5 by sliding the locking clips 5a to the rear.

5. Remove the battery compartment covers 5 from the battery compartments 4 , see Fig. C.

6. Pull the protection wafers 3 out of the battery compartments as shown 4 , see Fig. B. The product 1 is now ready for operation.

Replacing batteries

If the COBLED
light becomes weaker, the batteries
2 are depleted and must be replaced. For this, proceed as follows, see Fig. C:

1. Unfold the product 1 .
2. Unlock the battery compartment cover 5 by sliding the locking clips 5a to the rear.
3. Remove the battery compartment covers 5 from the battery compartments 4 .
4. Remove the depleted batteries.
5. Insert 4 new AA batteries into the battery compartments 4 according to the correct polarity.
6. Replace the battery compartment 5 covers and fold them closed until you hear the locking clips 5a click into place

Using the product Hanging up the product (Fig. D)
The support leg 6a can be folded out and then serves as a suspension hook.

1. Press on the catch 7 and unlock it.
2. Fold out the supporting leg 6a.
3. Hang the product 1 over a pole/rope or on a hook

NOTE!
The pole/rope or hook must be such that it can support
the weight of the product.

• To secure against falling down, fold in the stand leg 6a again if possible until the catch 7 clicks into place.
• If the hook function is no longer required, fold in the stand leg 6a again until the catch 7 clicks into place

Setting up the product (Fig. E)

Set up the product 1 in an appropriate place

NOTE!

• The surface should be even, so that the product cannot fall over. The place should have sufficient free space around the product.

• Place a protective blanket underneath the product, for example. Sensitive surfaces could become scratched by the product.
  The standing legs 6a/b of the product 1 can be rotated approx. 260° towards one another.

  1. Unfold the supporting legs 6a/b as far as they will go.
  2. Fold the two lamp segments 7a/b upwards
  • The lamp segments 7a/b are freely rotatable. This way, you can adjust where the product 1 should illuminate individually,

Attach product with magnetic function (Fig. F)

Magnets are integrated into the standing legs 6a/b. These can be used to attach the product 1 to magnetisable surfaces.

1. Fold up the standing legs 6a/b.
2. Attach the product 1 to a magnetisable surface as shown in Fig. F3)
   Switching the product on and off (Fig. E)

• To switch the product 1 on, press the push button 8 . Both lamp segments 7a/b will illuminate.
• A lamp segment is switched off by pressing the push button 8 again.
• The lamp segments 7a/b will switch over by pressing the push button 8 again.
• Pressing the push button 8 again switches the product 1 off.

Storing the product

• When not using the product 1 fold up the product 1 .
• store in a cool, dry place and protected from UV light

Cleaning and care instructions

! CAUTION!
Risk of injury!
Before cleaning, you must remove the batteries from the battery compartment. There is a risk of electric shock!

• only clean with a dry cloth
• do not use any strong detergents and/or chemicals
• do not immerse in water

Conformity declaration
This device complies with the fundamental requirements and other relevant regulations of the European Electromagnetic Compatibility Directive 2014/30/EU and the RoHS Directive 2011/65/EU. The complete original conformity declaration is available from the importer

Disposal

Disposal of the packaging

The packaging and operating instructions are made of 100 % environmentally friendly materials, which you may dispose of at local recycling centres.

Disposal of the product

The product may not be disposed of with normal household waste. Please find out about disposal options for the product from your local authority or town administration

Disposal of the battery / rechargeable batterie

• Defective or used rechargeable batteries have to be recycled in accordance with Directive 2006/66/EC and its amendments.
• Batteries and disposable batteries are not permitted to be disposed of with household waste. They contain harmful heavy metals. Marking: Pb (= lead), Hg (= mercury), Cd (= cadmium). You are legally obligated to return used batteries and rechargeable batteries. After use, you can either return batteries to our point of sale or in the direct vicinity (e.g. with a retailer or in municipal collection centres) free of charge. Batteries and rechargeable batteries are marked with a crossedout waste bin

Warranty

Warranty from TRADIX GmbH & Co. KG Dear customer, the warranty on this product is 3 years from the purchase date. In the event of defects in this product, you are entitled to exercise your statutory rights against the seller of the product. These statutory rights are not limited by our warranty described in the following

Warranty conditions

• The warranty begins on the date of purchase. Please keep the original receipt. This document is required as verification of the purchase.
• If a material or manufacturing defect arises within three years from the purchase date of this product, the product will be repaired or replaced, as per our choice, at no charge to you. This warranty service requires the submission of the purchase receipt and the defective product within the threeyear period and a short written description of the defect and when it arose.
• If the defect is covered by our warranty, the repaired or a new product will be returned to you. The warranty period does not restart with the repair or replacement of the product

Guarantee period and statutory claims for defects

The guarantee period will not be extended by the warranty. This also applies to replaced and repaired parts. Damage and defects which may possibly already exist upon purchase must be reported immediately after unpacking. After the guarantee period has expired, required repairs shall be subject to a charge.

Scope of guarantee

• The device has been carefully produced under strict quality guidelines and conscientiously inspected prior to delivery. The guarantee service applies to material or manufacturing faults. This guarantee does not extend to product parts, which are exposed to normal wear and tear and can therefore be regarded as wearing parts or to damage to fragile parts, e.g. switches, battery packs or which are made of glass.
• This guarantee shall lapse, if the product is damages, not used properly or maintained properly. For proper use of the product, all of the instructions in the operating instructions must be precisely complied with. Purposes and actions, which are dissuaded from or warned about in the operating instructions must be avoided.
• The product is only intended for private and not commercial use. In the case of abusive and improper handling, use of force and with interventions, whichare not performed by our authorised service branch, the guarantee shall lapse.

Processing in the case of a guarantee claim.

To ensure quick processing of your concern, please follow the instructions below:

• Please have the till receipt and article number available (e.g. IAN 367072_2101) as proof of the purchase.
• You can find the article number on the rating plate on the product, as an engraving on the product, the title place of your instructions (bottom left) or the sticker on the back or underside of the product.
• If malfunctions or other defects occur, first contact the service department below by telephone or email.
• You can then send a product that has been recorded as being defective, including the proof of purchase (till receipt) and stating what the defect is and when it occurred, postagefree to the service address provided to you

On www.lidlservice.com, you can download these an many other manuals, product videos and installation software.
With this QR code, you can directly reach the Lidl Service website (www.lidlservice.com) and can open your operating instructions be entering the article number (IAN)367072_2101

References

• de/
• VICE - VICE is the definitive guide to enlightening information.
• de/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>